[OpenWrt-Devel] Moving Ubiquity Nanostation M (XW) from ar71xx to ath79 [Was: openwrt-devel Digest, Vol 31, Issue 43]

[Petr Štetiar]

Joe Ayers <joe at ayerscasa.com> [2018-11-19 19:40:34]:

Thank you for testing.

> 1) Physical ports not functional.   frames are TX out, but RX not
> received back.  Switch configured out-of-box OK.

Ok, at least some progress.

> 2) wlan0 is functional and works correctly.  However, default for
> wifi-device is option disabled = '1', so not live on firstboot.

That's expected and standard OpenWrt behavior.

> [    0.444718] libphy: Fixed MDIO Bus: probed
> [    0.786402] libphy: ag71xx_mdio: probed
> [    0.793193] switch0: Atheros AR8236 rev. 1 switch registered on mdio-bus.0
> [    1.137115] ag71xx 19000000.eth: connected to PHY at mdio-bus.0:04 [uid=004dd043, driver=Atheros AR8216/AR8236/AR8316]
> [    1.148755] eth0: Atheros AG71xx at 0xb9000000, irq 4, mode:MII

Please can you provide also output of `swconfig dev switch0 show` from the
same ath79 broken image?

Can you please provide the same outputs (dmesg lines, swconfig) from firmware
which is working for you? It's firmware image from 18.06 release, am I correct?

Can you please try to run latest image[1] from development snapshot and check
if that works for you? 

Thanks!

1. https://downloads.openwrt.org/snapshots/targets/ar71xx/generic/openwrt-ar71xx-generic-ubnt-nano-m-xw-squashfs-factory.bin

-- ynezz

_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel