[OpenWrt-Devel] [PATCH 3/4] ath79: add Netgear WNR612 v2

Zoltan HERPAI wigyori at uid0.hu
Wed Jun 13 04:51:52 EDT 2018


Netgear WNR612 v2:
 - cpu Atheros AR7240 (Python) @400MHz
 - flash 4MB
 - ram 32MB
 - ethernet 10/100: 1xwan + 2xlan (only two)
 - radio AR9285

As there is a rebranded WNR612v2 called ON Networks N150R, add
a dtsi which includes all device support, and add a separate dts
for the board only (allowing for a separate one for the subsequent
N150R).

Signed-off-by: Zoltan HERPAI <wigyori at uid0.hu>
---
 target/linux/ath79/base-files/etc/board.d/01_leds  |   6 +
 .../linux/ath79/base-files/etc/board.d/02_network  |   5 +
 .../etc/hotplug.d/firmware/10-ath9k-eeprom         |   1 +
 .../linux/ath79/dts/ar7240_netgear_wnr612-v2.dts   |  10 ++
 .../linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi  | 147 +++++++++++++++++++++
 target/linux/ath79/image/Makefile                  |   1 +
 target/linux/ath79/image/tiny-netgear.mk           |  19 +++
 7 files changed, 189 insertions(+)
 create mode 100644 target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts
 create mode 100644 target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi
 create mode 100644 target/linux/ath79/image/tiny-netgear.mk

diff --git a/target/linux/ath79/base-files/etc/board.d/01_leds b/target/linux/ath79/base-files/etc/board.d/01_leds
index 0ba03b2..ee6568e 100755
--- a/target/linux/ath79/base-files/etc/board.d/01_leds
+++ b/target/linux/ath79/base-files/etc/board.d/01_leds
@@ -27,6 +27,12 @@ case "$board" in
 "glinet,ar150")
 	ucidef_set_led_wlan "wlan" "WLAN" "gl-ar150:orange:wlan" "phy0tpt"
 	;;
+"netgear,wnr612-v2")
+	ucidef_set_led_netdev "wan" "WAN" "netgear:green:wan" "eth0"
+	ucidef_set_led_wlan "wlan" "WLAN" "netgear:green:wlan" "phy0tpt"
+	ucidef_set_led_switch "lan1" "LAN1" "netgear:green:lan1" "switch0" "0x02" "0x0f"
+	ucidef_set_led_switch "lan2" "LAN2" "netgear:green:lan2" "switch0" "0x04" "0x0f"
+	;;
 "tplink,tl-mr3020-v1")
 	ucidef_set_led_switch "lan" "LAN" "tp-link:green:lan" "switch0" "0x02"
 	;;
diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network
index 8e3c917..f1f4bd0 100755
--- a/target/linux/ath79/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/base-files/etc/board.d/02_network
@@ -26,6 +26,11 @@ ath79_setup_interfaces()
 	"glinet,ar150")
 		ucidef_set_interfaces_lan_wan "eth1" "eth0"
 		;;
+	"netgear,wnr612-v2")
+		ucidef_set_interfaces_lan_wan "eth1.1" "eth0"
+		ucidef_add_switch "switch0" \
+		"0 at eth1" "1:lan" "2:lan" "3:lan:3" "4:lan:4"
+		;;
 	"tplink,tl-mr3020-v1")
 		ucidef_set_interface_lan "eth0.1"
 		ucidef_add_switch "switch0" "0 at eth0" "1:lan"
diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
index 498cc4e..1ed7460 100644
--- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
+++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/10-ath9k-eeprom
@@ -54,6 +54,7 @@ case "$FIRMWARE" in
 	"tplink,tl-wdr4300")
 		ath9k_eeprom_extract "art" 20480 1088
 		;;
+	"netgear,wnr612-v2"|\
 	"tplink,tl-wr740n-v2"|\
 	"ubnt,unifi")
 		ath9k_eeprom_extract "art" 4096 2048
diff --git a/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts
new file mode 100644
index 0000000..d804064
--- /dev/null
+++ b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dts
@@ -0,0 +1,10 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include "ar7240_netgear_wnr612-v2.dtsi"
+
+/ {
+	model = "Netgear WNR612 v2";
+	compatible = "netgear,wnr612-v2";
+};
+
diff --git a/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi
new file mode 100644
index 0000000..b86147e
--- /dev/null
+++ b/target/linux/ath79/dts/ar7240_netgear_wnr612-v2.dtsi
@@ -0,0 +1,147 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "ar7240.dtsi"
+
+/ {
+	compatible = "netgear,wnr612-v2", "qca,ar7240";
+	model = "Netgear WNR612 V2";
+
+	aliases {
+		led-status = &led_power;
+	};
+
+	memory at 0 {
+		device_type = "memory";
+		reg = <0x0 0x2000000>;
+	};
+
+	gpio-keys-polled {
+		compatible = "gpio-keys-polled";
+		#address-cells = <1>;
+		#size-cells = <0>;
+		poll-interval = <20>;
+
+		reset {
+			label = "reset";
+			linux,code = <KEY_RESTART>;
+			gpios = <&ath9k 7 GPIO_ACTIVE_LOW>;
+			debounce-interval = <60>;
+		};
+	};
+
+	gpio-leds {
+		compatible = "gpio-leds";
+		led_power: power {
+			label = "netgear:green:power";
+			gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
+		};
+
+		lan1 {
+			label = "netgear:green:lan1";
+			gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+		};
+
+		lan2 {
+			label = "netgear:green:lan2";
+			gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+		};
+
+		wan {
+			label = "netgear:green:wan";
+			gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+		};
+
+		wlan {
+			label = "netgear:green:wlan";
+			gpios = <&ath9k 1 GPIO_ACTIVE_LOW>;
+			default-state = "off";
+			linux,default-trigger = "phy0tpt";
+		};
+	};
+};
+
+&spi {
+	status = "okay";
+	num-cs = <1>;
+
+	flash at 0 {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		spi-max-frequency = <25000000>;
+
+		partitions {
+			compatible = "fixed-partitions";
+			#address-cells = <1>;
+			#size-cells = <1>;
+
+			uboot: partition at 0 {
+				reg = <0x0 0x40000>;
+				label = "u-boot";
+				read-only;
+			};
+
+			partition at 1 {
+				reg = <0x40000 0x10000>;
+				label = "u-boot-env";
+			};
+
+			partition at 2 {
+				reg = <0x50000 0x3a0000>;
+				label = "firmware";
+			};
+
+			partition at 3 {
+				reg = <0x3f0000 0x10000>;
+				label = "art";
+				read-only;
+			};
+		};
+	};
+};
+
+&eth0 {
+	status = "okay";
+
+	phy-handle = <&phy4>;
+
+	mtd-mac-address = <&uboot 0x1fc00>;
+	mtd-mac-address-increment = <(-1)>;
+};
+
+&eth1 {
+	status = "okay";
+
+	mtd-mac-address = <&uboot 0x1fc00>;
+	mtd-mac-address-increment = <1>;
+};
+
+&mdio0 {
+	status = "okay";
+
+	phy4: ethernet-phy at 4 {
+		reg = <4>;
+		phy-mode = "mii";
+	};
+};
+
+&pcie {
+	status = "okay";
+
+	ath9k: wifi at 168c,002b {
+		compatible = "pci168c,002b";
+		reg = <0x0000 0 0 0 0>;
+		qca,no-eeprom;
+		#gpio-cells = <2>;
+		gpio-controller;
+	};
+};
+
+&uart {
+	status = "okay";
+};
diff --git a/target/linux/ath79/image/Makefile b/target/linux/ath79/image/Makefile
index 34dd819..defd8f0 100644
--- a/target/linux/ath79/image/Makefile
+++ b/target/linux/ath79/image/Makefile
@@ -72,6 +72,7 @@ include ./generic-tp-link.mk
 include ./generic-ubnt.mk
 endif
 ifeq ($(SUBTARGET),tiny)
+include ./tiny-netgear.mk
 include ./tiny-tp-link.mk
 endif
 $(eval $(call BuildImage))
diff --git a/target/linux/ath79/image/tiny-netgear.mk b/target/linux/ath79/image/tiny-netgear.mk
new file mode 100644
index 0000000..81f83fd
--- /dev/null
+++ b/target/linux/ath79/image/tiny-netgear.mk
@@ -0,0 +1,19 @@
+include ./common-netgear.mk
+
+
+define Device/netgear_wnr612-v2
+  ATH_SOC := ar7240
+  DEVICE_TITLE := Netgear WNR612v2
+  DEVICE_DTS := ar7240_netgear_wnr612-v2
+  NETGEAR_KERNEL_MAGIC := 0x32303631
+  KERNEL := kernel-bin | append-dtb | lzma -d20 | netgear-uImage lzma
+  KERNEL_INITRAMFS := kernel-bin | append-dtb | lzma -d20 | netgear-uImage lzma
+  NETGEAR_BOARD_ID := REALWNR612V2
+  IMAGE_SIZE := 3904k
+  IMAGES := sysupgrade.bin factory.img
+  IMAGE/default := append-kernel | pad-to $$$$(BLOCKSIZE) | netgear-squashfs | append-rootfs | pad-rootfs
+  IMAGE/sysupgrade.bin := $$(IMAGE/default) | append-metadata | check-size $$$$(IMAGE_SIZE)
+  IMAGE/factory.img := $$(IMAGE/default) | netgear-dni | check-size $$$$(IMAGE_SIZE)
+  SUPPORTED_DEVICES := netgear,wnr612-v2 wnr612-v2
+endef
+TARGET_DEVICES += netgear_wnr612-v2
-- 
2.1.4


_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/listinfo/openwrt-devel



More information about the openwrt-devel mailing list