[OpenWrt-Devel] [PATCH] ramips: preinit: use iproute2 instead of vconfig

Daniel Golle daniel at makrotopia.org
Thu Oct 29 10:46:12 EDT 2015

Replace use of vconfig with the corresponding iproute2 syntax in

The switch reset work-around needed on some ramips targets used the
deprecated vconfig tool to bring up the pre-init/failsafe interface.
This doesn't work on recent builds where vconfig is no longer being
deployed, resulting in the device being unreachable when triggered
into failsafe mode.

Signed-off-by: Daniel Golle <daniel at makrotopia.org>
 .../linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips   | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
index 90b6d15..3dce1b6 100644
--- a/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
+++ b/target/linux/ramips/base-files/lib/preinit/07_set_preinit_iface_ramips
@@ -23,8 +23,8 @@ ramips_set_preinit_iface() {
 		swconfig dev rt305x vlan 1 set ports "0 6"
 		swconfig dev rt305x port 6 set untag 0
 		swconfig dev rt305x set apply 1
-		vconfig add eth0 1
-		ifconfig eth0 up
+		ip link add link eth0 name eth0.1 type vlan id 1
+		ip link set eth0 up
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org

More information about the openwrt-devel mailing list