[OpenWrt-Devel] [PATCH] ar71xx: add support for the UniFi AP Outdoor Plus

Kirill Berezin kyb22 at rol.ru
Tue May 26 02:39:10 EDT 2015


 > I haven't been able to get the reset button on boot to work for UniFi.
 > I use UART to pull up the boot-loader. Then use "urescue" to tftp the
 > UniFi image back on.

reset button works, but it's not easy to get whether it is pressed or 
not. If a reset button pressed then after a while AP light a pale blue 
for a couple of seconds then blinks with two colors.

To recover you need an image of jffs2 partition. I made a copy from 
working system and used this copy for recovery. I wrote it in openwrt 
with mtd to firmware partition.

The image bundled with a controller contains a bootloader and a kernel, 
but it lacks a root filesystem. Moreover the stock bootloader can't 
write this image, so the procedure published in ubiquity forums doesn't 
work for ap+.

Kirill.
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel



More information about the openwrt-devel mailing list