[PATCH] lib: sbi_dbtr: use range check for shared memory domain validation

[liutong]

sbi_dbtr_setup_shmem() validates the shared memory address using
sbi_domain_check_addr(), which only checks a single address. However,
subsequent DBTR operations (install, read, update) access up to
total_trigs * sizeof(sbi_dbtr_shmem_entry) bytes starting from that
address. If the shared memory region spans a domain boundary, accesses
beyond the first byte could violate domain isolation.

Replace the single-address check with sbi_domain_check_addr_range() to
validate the entire shared memory region that DBTR operations will use.

Signed-off-by: liutong <liutong at iscas.ac.cn>
---
 lib/sbi/sbi_dbtr.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/lib/sbi/sbi_dbtr.c b/lib/sbi/sbi_dbtr.c
index 01047969..983f0f6a 100644
--- a/lib/sbi/sbi_dbtr.c
+++ b/lib/sbi/sbi_dbtr.c
@@ -304,9 +304,10 @@ int sbi_dbtr_setup_shmem(const struct sbi_domain *dom, unsigned long smode,
 	if (shmem_phys_hi)
 		return SBI_EINVALID_ADDR;
 
-	if (dom && !sbi_domain_check_addr(dom,
-		  DBTR_SHMEM_MAKE_PHYS(shmem_phys_hi, shmem_phys_lo), smode,
-		  SBI_DOMAIN_READ | SBI_DOMAIN_WRITE))
+	if (dom && !sbi_domain_check_addr_range(dom,
+		  DBTR_SHMEM_MAKE_PHYS(shmem_phys_hi, shmem_phys_lo),
+		  hart_state->total_trigs * sizeof(union sbi_dbtr_shmem_entry),
+		  smode, SBI_DOMAIN_READ | SBI_DOMAIN_WRITE))
 		return SBI_ERR_INVALID_ADDRESS;
 
 	hart_state->shmem.phys_lo = shmem_phys_lo;
-- 
2.34.1