[PATCH 2/2] platform: generic: allwinner: Advertise nonretentive suspend
Samuel Holland
samuel at sholland.org
Wed Dec 28 11:11:24 PST 2022
Add D1's nonretentive suspend state to the devicetree so S-mode software
knows about it and can use it.
Latency and power measurements were taken on an Allwinner Nezha board:
- Entry latency was measured from the beginning of sbi_ecall_handler()
to before the call to wfi() in sun20i_d1_hart_suspend().
- Exit latency was measured from the beginning of sbi_init() to before
the call to sbi_hart_switch_mode() in init_warmboot().
- There was a 17.5 mW benefit from non-retentive suspend compared to
WFI, with a 170 mW cost during the 107 us entry/exit period. This
provides a break-even point around 1040 us. Residency includes entry
latency, so round this up to 1100 us.
- The hardware power sequence latency (after the WFI) is assumed to be
negligible, so set the wakeup latency to the exit latency.
Signed-off-by: Samuel Holland <samuel at sholland.org>
---
platform/generic/allwinner/sun20i-d1.c | 20 ++++++++++++++++++++
1 file changed, 20 insertions(+)
diff --git a/platform/generic/allwinner/sun20i-d1.c b/platform/generic/allwinner/sun20i-d1.c
index 1da9e5b..8ca556e 100644
--- a/platform/generic/allwinner/sun20i-d1.c
+++ b/platform/generic/allwinner/sun20i-d1.c
@@ -12,6 +12,7 @@
#include <sbi/sbi_error.h>
#include <sbi/sbi_hsm.h>
#include <sbi/sbi_pmu.h>
+#include <sbi_utils/fdt/fdt_fixup.h>
#include <sbi_utils/fdt/fdt_helper.h>
#include <sbi_utils/irqchip/fdt_irqchip_plic.h>
@@ -202,6 +203,24 @@ static int sun20i_d1_final_init(bool cold_boot, const struct fdt_match *match)
return 0;
}
+static const struct sbi_cpu_idle_state sun20i_d1_cpu_idle_states[] = {
+ {
+ .name = "cpu-nonretentive",
+ .suspend_param = SBI_HSM_SUSPEND_NON_RET_DEFAULT,
+ .local_timer_stop = true,
+ .entry_latency_us = 40,
+ .exit_latency_us = 67,
+ .min_residency_us = 1100,
+ .wakeup_latency_us = 67,
+ },
+ { }
+};
+
+static int sun20i_d1_fdt_fixup(void *fdt, const struct fdt_match *match)
+{
+ return fdt_add_cpu_idle_states(fdt, sun20i_d1_cpu_idle_states);
+}
+
static void thead_c9xx_pmu_ctr_enable_irq(uint32_t ctr_idx)
{
unsigned long mip_val;
@@ -265,5 +284,6 @@ static const struct fdt_match sun20i_d1_match[] = {
const struct platform_override sun20i_d1 = {
.match_table = sun20i_d1_match,
.final_init = sun20i_d1_final_init,
+ .fdt_fixup = sun20i_d1_fdt_fixup,
.extensions_init = sun20i_d1_extensions_init,
};
--
2.37.4
More information about the opensbi
mailing list