[PATCH 09/21] riscv: dma-mapping: skip invalidation before bidirectional DMA

Arnd Bergmann arnd at arndb.de
Fri May 5 06:18:54 PDT 2023


On Fri, May 5, 2023, at 07:47, Guo Ren wrote:
> On Mon, Mar 27, 2023 at 8:15 PM Arnd Bergmann <arnd at kernel.org> wrote:

>>
>> riscv also invalidates the caches before the transfer, which does
>> not appear to serve any purpose.
> Yes, we can't guarantee the CPU pre-load cache lines randomly during
> dma working.
>
> But I've two purposes to keep invalidates before dma transfer:
>  - We clearly tell the CPU these cache lines are invalid. The caching
> algorithm would use these invalid slots first instead of replacing
> valid ones.
>  - Invalidating is very cheap. Actually, flush and clean have the same
> performance in our machine.

The main purpose of the series was to get consistent behavior on
all machines, so I really don't want a custom optimization on
one architecture. You make a good point about cacheline reuse
after invalidation, but if we do that, I'd suggest doing this
across all architectures.

> So, how about:
>
> diff --git a/arch/riscv/mm/dma-noncoherent.c b/arch/riscv/mm/dma-noncoherent.c
> index d919efab6eba..2c52fbc15064 100644
> --- a/arch/riscv/mm/dma-noncoherent.c
> +++ b/arch/riscv/mm/dma-noncoherent.c
> @@ -22,8 +22,6 @@ void arch_sync_dma_for_device(phys_addr_t paddr, size_t size,
>                 ALT_CMO_OP(clean, vaddr, size, riscv_cbom_block_size);
>                 break;
>         case DMA_FROM_DEVICE:
> -               ALT_CMO_OP(clean, vaddr, size, riscv_cbom_block_size);
> -               break;
>         case DMA_BIDIRECTIONAL:
>                 ALT_CMO_OP(flush, vaddr, size, riscv_cbom_block_size);
>                 break;

This is something we can consider. Unfortunately, this is something
that no architecture (except pa-risc, which has other problems)
does at the moment, so we'd probably need to have a proper debate
about this.

We already have two conflicting ways to handle DMA_FROM_DEVICE,
either invalidate/invalidate, or clean/invalidate. I can see
that flush/invalidate may be a sensible option as well, but I'd
want to have that discussion after the series is complete, so
we can come to a generic solution that has the same documented
behavior across all architectures.

In particular, if we end up moving arm64 and riscv back to the
traditional invalidate/invalidate for DMA_FROM_DEVICE and
document that driver must not rely on buffers getting cleaned
before a partial DMA_FROM_DEVICE, the question between clean
or flush becomes moot as well.

> @@ -42,7 +40,7 @@ void arch_sync_dma_for_cpu(phys_addr_t paddr, size_t size,
>                 break;
>         case DMA_FROM_DEVICE:
>         case DMA_BIDIRECTIONAL:
>                 /* I'm not sure all drivers have guaranteed cacheline
> alignment. If not, this inval would cause problems */
> -               ALT_CMO_OP(flush, vaddr, size, riscv_cbom_block_size);
> +               ALT_CMO_OP(inval, vaddr, size, riscv_cbom_block_size);
>                 break;

This is my original patch, and I would not mix it with the other
change. The problem with non-aligned DMA_BIDIRECTIONAL buffers in
is that both flush and inval would be wrong if you get simultaneous
writes from device and cpu to the same cache line, so there is
no way to win this. Using inval instead of flush would at least
work if the CPU data in the cacheline is read-only from the CPU,
so that seems better than something that is always wrong.

The documented API is that sharing the cache line is not allowed
at all, so anything that would observe a difference between the
two is also a bug. One idea that we have considered already is
that we could overwrite the unused bits of the cacheline with
poison values and/or mark them as invalid using KASAN for debugging
purposes, to find drivers that already violate this.

      Arnd



More information about the linux-snps-arc mailing list