[PATCH v3 3/7] i2c: bcm2835: Use dev_dbg logging on transfer errors

[Noralf Trønnes]

Writing to an AT24C32 generates on average 2x i2c transfer errors per
32-byte page write. Which amounts to a lot for a 4k write. This is due
to the fact that the chip doesn't respond during it's internal write
cycle when the at24 driver tries and retries the next write.
Only a handful drivers use dev_err() on transfer error, so switch to
dev_dbg() instead.

Signed-off-by: Noralf Trønnes <noralf at tronnes.org>
---

Changes:
- use dev_dbg instead of dev_err_ratelimited

 drivers/i2c/busses/i2c-bcm2835.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/i2c/busses/i2c-bcm2835.c b/drivers/i2c/busses/i2c-bcm2835.c
index df036ed..8cdb139 100644
--- a/drivers/i2c/busses/i2c-bcm2835.c
+++ b/drivers/i2c/busses/i2c-bcm2835.c
@@ -207,7 +207,7 @@ static int bcm2835_i2c_xfer_msg(struct bcm2835_i2c_dev *i2c_dev,
 	    (msg->flags & I2C_M_IGNORE_NAK))
 		return 0;

-	dev_err(i2c_dev->dev, "i2c transfer failed: %x\n", i2c_dev->msg_err);
+	dev_dbg(i2c_dev->dev, "i2c transfer failed: %x\n", i2c_dev->msg_err);

 	if (i2c_dev->msg_err & BCM2835_I2C_S_ERR)
 		return -EREMOTEIO;
--
2.8.2