[PATCH 1/1] mmc: sdhci-bcm2835: added quirk and removed udelay in write ops
Scott Branden
sbranden at broadcom.com
Tue Oct 14 19:02:22 PDT 2014
Added quirk SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12 present in controller.
Removed udelay in write ops by using shadow registers for 16 bit
accesses to 32-bit registers (where necessary).
Optimized 32-bit operations when doing 8/16 register accesses.
Signed-off-by: Scott Branden <sbranden at broadcom.com>
---
drivers/mmc/host/sdhci-bcm2835.c | 139 ++++++++++++++++++--------------------
1 file changed, 66 insertions(+), 73 deletions(-)
diff --git a/drivers/mmc/host/sdhci-bcm2835.c b/drivers/mmc/host/sdhci-bcm2835.c
index 439d259..d967a4f 100644
--- a/drivers/mmc/host/sdhci-bcm2835.c
+++ b/drivers/mmc/host/sdhci-bcm2835.c
@@ -25,42 +25,28 @@
#include "sdhci-pltfm.h"
/*
- * 400KHz is max freq for card ID etc. Use that as min card clock. We need to
- * know the min to enable static calculation of max BCM2835_SDHCI_WRITE_DELAY.
- */
-#define MIN_FREQ 400000
-
-/*
* The Arasan has a bugette whereby it may lose the content of successive
- * writes to registers that are within two SD-card clock cycles of each other
- * (a clock domain crossing problem). It seems, however, that the data
- * register does not have this problem, which is just as well - otherwise we'd
- * have to nobble the DMA engine too.
+ * writes to the same register that are within two SD-card clock cycles of
+ * each other (a clock domain crossing problem). Problem does not happen with
+ * data.
+ * This wouldn't be a problem with the code except that we can only write the
+ * controller with 32-bit writes. So two different 16-bit registers in the
+ * written back to back creates the problem.
*
- * This should probably be dynamically calculated based on the actual card
- * frequency. However, this is the longest we'll have to wait, and doesn't
- * seem to slow access down too much, so the added complexity doesn't seem
- * worth it for now.
- *
- * 1/MIN_FREQ is (max) time per tick of eMMC clock.
- * 2/MIN_FREQ is time for two ticks.
- * Multiply by 1000000 to get uS per two ticks.
- * *1000000 for uSecs.
- * +1 for hack rounding.
+ * In reality, this only happens when a SDHCI_BLOCK_SIZE and SDHCI_BLOCK_COUNT
+ * are written followed by SDHCI_TRANSFER_MODE and SDHCI_COMMAND.
+ * The BLOCK_SIZE and BLOCK_COUNT are meaningless until a command issued so
+ * the work around can be further optimized. We can keep shadow values of
+ * BLOCK_SIZE, BLOCK_COUNT, and TRANSFER_MODE until a COMMAND is issued.
+ * Then, write the BLOCK_SIZE+BLOCK_COUNT in a single 32-bit write followed
+ * by the TRANSFER+COMMAND in another 32-bit write.
*/
-#define BCM2835_SDHCI_WRITE_DELAY (((2 * 1000000) / MIN_FREQ) + 1)
-struct bcm2835_sdhci {
- u32 shadow;
+struct bcm2835_sdhci_host {
+ u32 shadow_cmd;
+ u32 shadow_blk;
};
-static void bcm2835_sdhci_writel(struct sdhci_host *host, u32 val, int reg)
-{
- writel(val, host->ioaddr + reg);
-
- udelay(BCM2835_SDHCI_WRITE_DELAY);
-}
-
static inline u32 bcm2835_sdhci_readl(struct sdhci_host *host, int reg)
{
u32 val = readl(host->ioaddr + reg);
@@ -71,76 +57,83 @@ static inline u32 bcm2835_sdhci_readl(struct sdhci_host *host, int reg)
return val;
}
-static void bcm2835_sdhci_writew(struct sdhci_host *host, u16 val, int reg)
-{
- struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
- struct bcm2835_sdhci *bcm2835_host = pltfm_host->priv;
- u32 oldval = (reg == SDHCI_COMMAND) ? bcm2835_host->shadow :
- bcm2835_sdhci_readl(host, reg & ~3);
- u32 word_num = (reg >> 1) & 1;
- u32 word_shift = word_num * 16;
- u32 mask = 0xffff << word_shift;
- u32 newval = (oldval & ~mask) | (val << word_shift);
-
- if (reg == SDHCI_TRANSFER_MODE)
- bcm2835_host->shadow = newval;
- else
- bcm2835_sdhci_writel(host, newval, reg & ~3);
-}
-
static u16 bcm2835_sdhci_readw(struct sdhci_host *host, int reg)
{
- u32 val = bcm2835_sdhci_readl(host, (reg & ~3));
- u32 word_num = (reg >> 1) & 1;
- u32 word_shift = word_num * 16;
- u32 word = (val >> word_shift) & 0xffff;
-
+ u32 val = bcm2835_sdhci_readl(host->ioaddr, (reg & ~3));
+ u16 word = val >> (reg << 3 & 0x18) & 0xffff;
return word;
}
-static void bcm2835_sdhci_writeb(struct sdhci_host *host, u8 val, int reg)
+static u8 bcm2835_sdhci_readb(struct sdhci_host *host, int reg)
{
- u32 oldval = bcm2835_sdhci_readl(host, reg & ~3);
- u32 byte_num = reg & 3;
- u32 byte_shift = byte_num * 8;
- u32 mask = 0xff << byte_shift;
- u32 newval = (oldval & ~mask) | (val << byte_shift);
+ u32 val = bcm2835_sdhci_readl(host->ioaddr, (reg & ~3));
+ u8 byte = val >> (reg << 3 & 0x18) & 0xff;
+ return byte;
+}
- bcm2835_sdhci_writel(host, newval, reg & ~3);
+static void bcm2835_sdhci_writel(struct sdhci_host *host, u32 val, int reg)
+{
+ writel(val, host->ioaddr + reg);
}
-static u8 bcm2835_sdhci_readb(struct sdhci_host *host, int reg)
+static void bcm2835_sdhci_writew(struct sdhci_host *host, u16 val, int reg)
{
- u32 val = bcm2835_sdhci_readl(host, (reg & ~3));
- u32 byte_num = reg & 3;
- u32 byte_shift = byte_num * 8;
- u32 byte = (val >> byte_shift) & 0xff;
+ struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
+ struct bcm2835_sdhci_host *bcm2835_host = pltfm_host->priv;
+ u32 word_shift = reg << 3 & 0x18;
+ u32 mask = 0xffff << word_shift;
+ u32 oldval;
+ u32 newval;
+
+ if (reg == SDHCI_COMMAND) {
+ if (bcm2835_host->shadow_blk != 0) {
+ writel(bcm2835_host->shadow_blk,
+ host->ioaddr + SDHCI_BLOCK_SIZE);
+ bcm2835_host->shadow_blk = 0;
+ }
+ oldval = bcm2835_host->shadow_cmd;
+ } else if (reg == SDHCI_BLOCK_SIZE || reg == SDHCI_BLOCK_COUNT) {
+ oldval = bcm2835_host->shadow_blk;
+ } else {
+ oldval = readl(host->ioaddr + (reg & ~3));
+ }
+ newval = (oldval & ~mask) | (val << word_shift);
- return byte;
+ if (reg == SDHCI_TRANSFER_MODE)
+ bcm2835_host->shadow_cmd = newval;
+ else if (reg == SDHCI_BLOCK_SIZE || reg == SDHCI_BLOCK_COUNT)
+ bcm2835_host->shadow_blk = newval;
+ else
+ writel(newval, host->ioaddr + (reg & ~3));
}
-static unsigned int bcm2835_sdhci_get_min_clock(struct sdhci_host *host)
+static void bcm2835_sdhci_writeb(struct sdhci_host *host, u8 val, int reg)
{
- return MIN_FREQ;
+ u32 oldval = readl(host->ioaddr + (reg & ~3));
+ u32 byte_shift = reg << 3 & 0x18;
+ u32 mask = 0xff << byte_shift;
+ u32 newval = (oldval & ~mask) | (val << byte_shift);
+
+ writel(newval, host->ioaddr + (reg & ~3));
}
static const struct sdhci_ops bcm2835_sdhci_ops = {
- .write_l = bcm2835_sdhci_writel,
- .write_w = bcm2835_sdhci_writew,
- .write_b = bcm2835_sdhci_writeb,
.read_l = bcm2835_sdhci_readl,
.read_w = bcm2835_sdhci_readw,
.read_b = bcm2835_sdhci_readb,
+ .write_l = bcm2835_sdhci_writel,
+ .write_w = bcm2835_sdhci_writew,
+ .write_b = bcm2835_sdhci_writeb,
.set_clock = sdhci_set_clock,
.get_max_clock = sdhci_pltfm_clk_get_max_clock,
- .get_min_clock = bcm2835_sdhci_get_min_clock,
.set_bus_width = sdhci_set_bus_width,
.reset = sdhci_reset,
.set_uhs_signaling = sdhci_set_uhs_signaling,
};
static const struct sdhci_pltfm_data bcm2835_sdhci_pdata = {
- .quirks = SDHCI_QUIRK_BROKEN_CARD_DETECTION |
+ .quirks = SDHCI_QUIRK_MULTIBLOCK_READ_ACMD12 |
+ SDHCI_QUIRK_BROKEN_CARD_DETECTION |
SDHCI_QUIRK_DATA_TIMEOUT_USES_SDCLK,
.ops = &bcm2835_sdhci_ops,
};
@@ -148,7 +141,7 @@ static const struct sdhci_pltfm_data bcm2835_sdhci_pdata = {
static int bcm2835_sdhci_probe(struct platform_device *pdev)
{
struct sdhci_host *host;
- struct bcm2835_sdhci *bcm2835_host;
+ struct bcm2835_sdhci_host *bcm2835_host;
struct sdhci_pltfm_host *pltfm_host;
int ret;
--
1.7.9.5
More information about the linux-rpi-kernel
mailing list