[PATCH 1/2] clk: fixed-rate: use full DT node name

Stephen Warren swarren at wwwdotorg.org
Fri Feb 14 11:43:51 EST 2014


On 02/14/2014 03:35 AM, Mark Rutland wrote:
> On Fri, Feb 14, 2014 at 06:16:52AM +0000, Stephen Warren wrote:
>> clk-fixed-rate currently names clocks according to a node's name without
>> the unit address. When faced with the legal and technically correct DT
>> structure below, this causes rgistration attempts for 3 clocks with the
>> same name, 2 of which fail.
>>
>> 	clocks {
>> 		compatible = "simple-bus";
>> 		#address-cells = <1>;
>> 		#size-cells = <0>;
>>
>> 		clk_mmc: clock at 0 {
>> 			compatible = "fixed-clock";
>> 			reg = <0>;
>> ...
>> 		clk_i2c: clock at 1 {
>> 			compatible = "fixed-clock";
>> 			reg = <1>;
>> ...
>> 		clk_spi: clock at 2 {
>> 			compatible = "fixed-clock";
>> 			reg = <2>;
>> ...
> 
> I'd argue that this case isn't valid.
> 
> The fixed-clock binding doesn't define a reg, yet simple bus binding
> implies that the reg property of child nodes should be interpretted as
> the same address space as their parent (MMIO in this case?). The
> fixed-clock nodes reg proeprties clearly aren't MMIO addresses.
> 
> Additionally, the _requred_ ranges property is missing.

Oh, IIRC that was deliberate to indicate that the child address space
was disjoint from the parent address space.




More information about the linux-rpi-kernel mailing list