[PATCH v17 11/12] arm64: dts: rockchip: add NPU (RKNN) nodes to rk3576

Daniel Drake ddrake at baylibre.com
Wed Nov 18 04:28:19 PST 2026


Hi,

On 14/11/2026 03:05, Jiaxing Hu wrote:
> Each core is on its own power domain only: core 0 on PD_NPU0, core 1 on
> PD_NPU1. Measured with both cores running, the results are correct, and
> the nputop and npu domains above them are powered through the domain
> hierarchy.

No need to include lab notes; we assume you tested this work and found
it to be working before submission.

> Label PD_NPU so a board can connect the NPU supply. The IOMMUs use four
> clocks.
> 
> Also set CLK_RKNN_DSU0 to 594 MHz. Mainline sets neither its rate nor the
> NPU voltage. On the ROCK 4D the DSU runs at 786 MHz by default and the
> rail boots at 750 mV; with both cores running, each pass of the 5400-row
> test has 11 to 25 wrong words. At 594 MHz the test is all correct. In the
> vendor OPP table, the 500 MHz and 600 MHz steps both need 725 mV.

I found this wording a bit confusing. I think you're saying, the system
boots into Linux with 786MHz & 750mV, and that configuration gives bad
results.

I'm not clear why you picked 594 Hz then. What does the vendor kernel
do, are you matching that behaviour?




More information about the Linux-rockchip mailing list