[PATCH 0/5] iommu/arm-smmu-v3: power domain and clock of the RK3588 PCIe SMMU

[Heiko Stübner]

Am Dienstag, 10. November 2026, 09:40:44 Mitteleuropäische Normalzeit schrieb Shawn Lin:
> Cc: Simon and Finley
> 
> 在 2026/11/10 星期二 15:11, Arun Iyengar via B4 Relay 写道:
> > The MMU-600 in front of the PCIe controllers of the Rockchip RK3588
> > (mmu600_pcie) is enabled for every RK3588 board, but its node describes
> > neither the power domain it lives in (RK3588_PD_PCIE) nor its clock
> > (ACLK_MMU_PCIE). Both are held by any enabled PCIe controller, which is
> > why nobody noticed: on a board that enables no PCIe controller in that
> > domain (an Orange Pi 5 with its M.2 slot in SATA mode, or any RK3588
> > board without PCIe), genpd powers the domain off and the clock framework
> > gates the clock as unused after boot, while arm-smmu-v3 stays bound.
> > At reboot, arm_smmu_device_shutdown() then writes CR0 and polls CR0ACK on
> > the dead block, the interconnect stalls, "reboot: Restarting system" is
> > never reached and the board only comes back ~90 s later when the
> > watchdog fires.

We have a work-around for that in some boards, manually disabling the
smmu until now. As the SMMU is part of the SoC and always present
the general DT practice is to have it always enabled, as it does not
depend on the actual board design.

Hence we end up in the situation described above.

So this series fixes the actual underlying problem, making these
workarounds unnecessary in the future :-)


So definitly thanks a lot
Heiko