[PATCH V13 7/9] iio: imu: inv_icm42607: Add Accelerometer for icm42607

[Andy Shevchenko]

On Mon, Jun 15, 2026 at 12:25:50PM -0500, Chris Morgan wrote:

> Add icm42607 accelerometer sensor for icm42607.

...

> +static int inv_icm42607_accel_read_odr(struct inv_icm42607_state *st,
> +				       int *val, int *val2)
> +{
> +	unsigned int odr;
> +	unsigned int i;
> +
> +	guard(mutex)(&st->lock);
> +
> +	odr = st->conf.accel.odr;
> +
> +	for (i = 5; i < ARRAY_SIZE(inv_icm42607_accel_odr); ++i) {

Same comment stays. Why pre-increment?

> +		if (i == odr)
> +			break;
> +	}
> +	if (i >= ARRAY_SIZE(inv_icm42607_accel_odr))
> +		return -EINVAL;
> +
> +	*val = inv_icm42607_accel_odr[i][0];
> +	*val2 = inv_icm42607_accel_odr[i][1];
> +
> +	return IIO_VAL_INT_PLUS_MICRO;
> +}

...

> +static int inv_icm42607_accel_write_odr(struct iio_dev *indio_dev,
> +					int val, int val2)
> +{
> +	struct inv_icm42607_sensor_conf conf = INV_ICM42607_SENSOR_CONF_INIT;
> +	struct inv_icm42607_state *st = iio_device_get_drvdata(indio_dev);
> +	struct device *dev = regmap_get_device(st->map);
> +	unsigned int idx;
> +	int ret;
> +
> +	for (idx = 5; idx < ARRAY_SIZE(inv_icm42607_accel_odr); ++idx) {

Ditto.

> +		if (val == inv_icm42607_accel_odr[idx][0] &&
> +		    val2 == inv_icm42607_accel_odr[idx][1])
> +			break;
> +	}
> +	if (idx >= ARRAY_SIZE(inv_icm42607_accel_odr))
> +		return -EINVAL;
> +
> +	conf.odr = idx;
> +
> +	PM_RUNTIME_ACQUIRE_AUTOSUSPEND(dev, pm);
> +	ret = PM_RUNTIME_ACQUIRE_ERR(&pm);
> +	if (ret)
> +		return ret;
> +
> +	guard(mutex)(&st->lock);
> +
> +	return inv_icm42607_set_accel_conf(st, &conf, NULL);
> +}

...

> +int inv_icm42607_set_accel_conf(struct inv_icm42607_state *st,
> +				struct inv_icm42607_sensor_conf *conf,
> +				unsigned int *sleep_ms)
> +{
> +	struct inv_icm42607_sensor_conf *oldconf = &st->conf.accel;
> +	unsigned int val;
> +	int ret;
> +
> +	if (conf->mode < 0)
> +		conf->mode = oldconf->mode;

Also as per below.

> +	if (conf->fs < 0)
> +		conf->fs = oldconf->fs;
> +	if (conf->odr < 0)
> +		conf->odr = oldconf->odr;

> +	if (conf->filter < 0)
> +		conf->filter = oldconf->filter;

This conditional is not immediately used below...

> +	if (conf->fs != oldconf->fs || conf->odr != oldconf->odr) {
> +		val = FIELD_PREP(INV_ICM42607_ACCEL_CONFIG0_FS_SEL_MASK, conf->fs);
> +		val |= FIELD_PREP(INV_ICM42607_ACCEL_CONFIG0_ODR_MASK, conf->odr);
> +		ret = regmap_write(st->map, INV_ICM42607_REG_ACCEL_CONFIG0, val);
> +		if (ret)
> +			return ret;
> +		oldconf->fs = conf->fs;
> +		oldconf->odr = conf->odr;
> +	}

...you can move it here.

> +	if (conf->filter != oldconf->filter) {
> +		if (conf->mode == INV_ICM42607_SENSOR_MODE_LOW_POWER) {
> +			val = FIELD_PREP(INV_ICM42607_ACCEL_CONFIG1_AVG_MASK, conf->filter);
> +			ret = regmap_update_bits(st->map, INV_ICM42607_REG_ACCEL_CONFIG1,
> +						 INV_ICM42607_ACCEL_CONFIG1_AVG_MASK, val);
> +		} else {
> +			val = FIELD_PREP(INV_ICM42607_ACCEL_CONFIG1_FILTER_MASK,
> +					 conf->filter);
> +			ret = regmap_update_bits(st->map, INV_ICM42607_REG_ACCEL_CONFIG1,
> +						 INV_ICM42607_ACCEL_CONFIG1_FILTER_MASK, val);
> +		}
> +		if (ret)
> +			return ret;
> +		oldconf->filter = conf->filter;
> +	}
> +
> +	return inv_icm42607_set_pwr_mgmt0(st, st->conf.gyro.mode, conf->mode,
> +					  st->conf.temp_en, sleep_ms);
> +}

-- 
With Best Regards,
Andy Shevchenko