fixup! media: synopsys: add driver for the designware mipi csi-2 receiver

[Michael Riesch]

Make smatch happy by adding braces around the initialization in switch
cases.

Signed-off-by: Michael Riesch <michael.riesch at collabora.com>
---
@Sakari could you try the following patch? I think this should solve the
issues with smatch/sparse you mentioned off-list.

 drivers/media/platform/synopsys/dw-mipi-csi2rx.c | 7 ++++---
 1 file changed, 4 insertions(+), 3 deletions(-)

diff --git a/drivers/media/platform/synopsys/dw-mipi-csi2rx.c
b/drivers/media/platform/synopsys/dw-mipi-csi2rx.c
index 29119a1a8d38..dc82223e312a 100644
--- a/drivers/media/platform/synopsys/dw-mipi-csi2rx.c
+++ b/drivers/media/platform/synopsys/dw-mipi-csi2rx.c
@@ -236,7 +236,7 @@ static int dw_mipi_csi2rx_start(struct
dw_mipi_csi2rx_device *csi2)
                return link_freq;

        switch (csi2->bus_type) {
-       case V4L2_MBUS_CSI2_DPHY:
+       case V4L2_MBUS_CSI2_DPHY: {
                struct phy_configure_opts_mipi_dphy *cfg = &opts.mipi_dphy;

                ret =
phy_mipi_dphy_get_default_config_for_hsclk(link_freq * 2,
@@ -254,7 +254,7 @@ static int dw_mipi_csi2rx_start(struct
dw_mipi_csi2rx_device *csi2)

                control |= SW_CPHY_EN(0);
                break;
-
+       }
        case V4L2_MBUS_CSI2_CPHY:
                /* TODO: implement CPHY configuration */
                return -EOPNOTSUPP;
@@ -293,7 +293,7 @@ dw_mipi_csi2rx_enum_mbus_code(struct v4l2_subdev *sd,
        struct dw_mipi_csi2rx_device *csi2 = to_csi2(sd);

        switch (code->pad) {
-       case DW_MIPI_CSI2RX_PAD_SRC:
+       case DW_MIPI_CSI2RX_PAD_SRC: {
                const struct v4l2_mbus_framefmt *sink_fmt;

                if (code->index)
@@ -304,6 +304,7 @@ dw_mipi_csi2rx_enum_mbus_code(struct v4l2_subdev *sd,
                code->code = sink_fmt->code;

                return 0;
+       }
        case DW_MIPI_CSI2RX_PAD_SINK:
                if (code->index > csi2->formats_num)
                        return -EINVAL;

-- 
2.39.5