[PATCH v7 1/5] dt-bindings: display: bridge: analogix-dp: Add data-lanes support for endpoint

[Luca Ceresoli]

On Wed, 19 Aug 2026 15:52:34 +0800, Damon Ding <damon.ding at rock-chips.com> wrote:
> Add data-lanes property support to the port at 1 endpoint for physical
> lane mapping configuration.
> 
> Lane mapping is mainly used for below scenarios:
> 1. Correct PCB lane swap and differential line routing crossover
>    without hardware changes;
> 2. Adapt mismatched lane pin definitions between SoC and eDP panel;
> 3. Support multiple panel hardware variants on the same board
>    by configuring data-lanes in device tree only.
> 
> [...]

Reviewed-by: Luca Ceresoli <luca.ceresoli at bootlin.com>

-- 
Luca Ceresoli, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com