[PATCH v4 05/10] drm/bridge: dw-hdmi-qp: Set bridge supported_formats

[Nicolas Frattaroli]

The drm_bridge "supported_formats" member stores a bitmask of supported
HDMI output formats if the bridge is in fact an HDMI bridge.

However, until now, the synopsys dw-hdmi-qp driver did not set this
member in the bridge it creates.

Set it based on the platform data's supported_formats member, and
default to BIT(HDMI_COLORSPACE_RGB) if it's absent, which preserves the
previous behaviour.

Signed-off-by: Nicolas Frattaroli <nicolas.frattaroli at collabora.com>
---
 drivers/gpu/drm/bridge/synopsys/dw-hdmi-qp.c | 5 +++++
 1 file changed, 5 insertions(+)

diff --git a/drivers/gpu/drm/bridge/synopsys/dw-hdmi-qp.c b/drivers/gpu/drm/bridge/synopsys/dw-hdmi-qp.c
index fe4c026280f0..cf888236bd65 100644
--- a/drivers/gpu/drm/bridge/synopsys/dw-hdmi-qp.c
+++ b/drivers/gpu/drm/bridge/synopsys/dw-hdmi-qp.c
@@ -1269,6 +1269,11 @@ struct dw_hdmi_qp *dw_hdmi_qp_bind(struct platform_device *pdev,
 		dev_warn(dev, "Set ref_clk_rate to vendor default\n");
 	}
 
+	if (plat_data->supported_formats)
+		hdmi->bridge.supported_formats = plat_data->supported_formats;
+	else
+		hdmi->bridge.supported_formats = BIT(HDMI_COLORSPACE_RGB);
+
 	dw_hdmi_qp_init_hw(hdmi);
 
 	ret = devm_request_threaded_irq(dev, plat_data->main_irq,

-- 
2.51.2