[PATCH] regulator: rk808: Add apply_bit for BUCK3 on RK809

[Mikhail Rudenko]

Gentle ping.

Also Cc more potential reviewers.

On 2024-10-17 at 21:37 +03, Mikhail Rudenko <mike.rudenko at gmail.com> wrote:

> Currently, RK809's BUCK3 regulator is modelled in the driver as a
> configurable regulator with 0.5-2.4V voltage range. But the voltage
> setting is not actually applied, because when bit 6 of
> PMIC_POWER_CONFIG register is set to 0 (default), BUCK3 output voltage
> is determined by the external feedback resistor. Fix this, by setting
> bit 6 when voltage selection is set. Existing users which do not
> specify voltage constraints in their device trees will not be affected
> by this change, since no voltage setting is applied in those cases,
> and bit 6 is not enabled.
>
> Signed-off-by: Mikhail Rudenko <mike.rudenko at gmail.com>
> ---
>  drivers/regulator/rk808-regulator.c | 2 ++
>  1 file changed, 2 insertions(+)
>
> diff --git a/drivers/regulator/rk808-regulator.c b/drivers/regulator/rk808-regulator.c
> index 14b60abd6afc..01a8d0487918 100644
> --- a/drivers/regulator/rk808-regulator.c
> +++ b/drivers/regulator/rk808-regulator.c
> @@ -1379,6 +1379,8 @@ static const struct regulator_desc rk809_reg[] = {
>  		.n_linear_ranges = ARRAY_SIZE(rk817_buck1_voltage_ranges),
>  		.vsel_reg = RK817_BUCK3_ON_VSEL_REG,
>  		.vsel_mask = RK817_BUCK_VSEL_MASK,
> +		.apply_reg = RK817_POWER_CONFIG,
> +		.apply_bit = RK817_BUCK3_FB_RES_INTER,
>  		.enable_reg = RK817_POWER_EN_REG(0),
>  		.enable_mask = ENABLE_MASK(RK817_ID_DCDC3),
>  		.enable_val = ENABLE_MASK(RK817_ID_DCDC3),
>
> ---
> base-commit: 9852d85ec9d492ebef56dc5f229416c925758edc
> change-id: 20241017-rk809-dcdc3-388632b4da03
>

--
Best regards,
Mikhail Rudenko