[PATCH v3 12/12] PCI: rockchip-ep: Handle PERST# signal in endpoint mode

[Damien Le Moal]

On 10/10/24 19:49, Manivannan Sadhasivam wrote:
>> +static int rockchip_pcie_ep_setup_irq(struct pci_epc *epc)
>> +{
>> +	struct rockchip_pcie_ep *ep = epc_get_drvdata(epc);
>> +	struct rockchip_pcie *rockchip = &ep->rockchip;
>> +	struct device *dev = rockchip->dev;
>> +	int ret;
>> +
>> +	if (!rockchip->ep_gpio)
>> +		return 0;
>> +
>> +	/* PCIe reset interrupt */
>> +	ep->perst_irq = gpiod_to_irq(rockchip->ep_gpio);
>> +	if (ep->perst_irq < 0) {
>> +		dev_err(dev, "No corresponding IRQ for PERST GPIO\n");
>> +		return ep->perst_irq;
>> +	}
>> +
>> +	ep->perst_asserted = true;
> 
> How come?

Yeah, a bit confusing. This is because the gpio active low / inactive high, so
as soon as we enable the IRQ, we are going to get one IRQ even though perst gpio
signal has not changed yet. So to be consistent with this, perst_asserted is
initialized to true so that on the first shot of
rockchip_pcie_ep_perst_irq_thread() we end up calling
rockchip_pcie_ep_perst_assert() as if we got an assert from the host (we have
not yet). I will add a comment clarifying that.



-- 
Damien Le Moal
Western Digital Research