[PATCH v4 4/4] media: platform: synopsys: Add support for hdmi input driver

George Stark gnstark at salutedevices.com
Sat Jul 20 16:43:44 PDT 2024


Hello everybody

On 7/19/24 15:40, Shreeya Patel wrote:
> Add initial support for the Synopsys DesignWare HDMI RX
> Controller Driver used by Rockchip RK3588. The driver
> supports:
>   - HDMI 1.4b and 2.0 modes (HDMI 4k at 60Hz)
>   - RGB888, YUV422, YUV444 and YCC420 pixel formats
>   - CEC
>   - EDID configuration
> 
> The hardware also has Audio and HDCP capabilities, but these are
> not yet supported by the driver.
> 
> Reviewed-by: Dmitry Osipenko <dmitry.osipenko at collabora.com>
> Tested-by: Dmitry Osipenko <dmitry.osipenko at collabora.com>
> Co-developed-by: Dingxian Wen <shawn.wen at rock-chips.com>
> Signed-off-by: Dingxian Wen <shawn.wen at rock-chips.com>
> Signed-off-by: Shreeya Patel <shreeya.patel at collabora.com>
> ---
> 
> Changes in v4 :-
>    - Create a separate config option for selecting the EDID
>      and enable it by default
>    - Improve the comment related to DV timings and move it
>      to the side of hdmirx_get_detected_timings
>    - Add 100ms delay before pulling the HPD high
>    - Do not return the detected timings from VIDIOC_G_DV_TIMINGS
>    - Drop the bus info from hdmirx_querycap
>    - If *num_planes != 0 then return 0 in hdmirx_queue_setup
>    - Set queue->min_queued_buffers to 1
>    - Drop q->allow_cache_hints = 0; as it's always 0 by default
>    - Add a comment for q->dma_attrs = DMA_ATTR_FORCE_CONTIGUOUS;
>    - Drop .read = vb2_fop_read as it's not supported by driver
>    - Remove redundant edid_init_data_600M
>    - Make HPD low when driver is loaded
>    - Add support for reading AVI Infoframe
>    - Remove msg_len checks from hdmirx_cec_transmit
>    - Add info about the CEC compliance test in the cover letter
>    - Add arbitration lost status
>    - Validate the physical address inside the EDID
> 
> Changes in v3 :-
>    - Use v4l2-common helper functions
> 
> Changes in v2 :-
>    - Fix checkpatch --strict warnings
>    - Rename resets, vo1-grf and HPD node names as per the DT changes
> 
>   drivers/media/platform/Kconfig                |    1 +
>   drivers/media/platform/Makefile               |    1 +
>   drivers/media/platform/synopsys/Kconfig       |    3 +
>   drivers/media/platform/synopsys/Makefile      |    2 +
>   .../media/platform/synopsys/hdmirx/Kconfig    |   27 +
>   .../media/platform/synopsys/hdmirx/Makefile   |    4 +
>   .../platform/synopsys/hdmirx/snps_hdmirx.c    | 2763 +++++++++++++++++
>   .../platform/synopsys/hdmirx/snps_hdmirx.h    |  394 +++
>   .../synopsys/hdmirx/snps_hdmirx_cec.c         |  285 ++
>   .../synopsys/hdmirx/snps_hdmirx_cec.h         |   44 +
>   10 files changed, 3524 insertions(+)
>   create mode 100644 drivers/media/platform/synopsys/Kconfig
>   create mode 100644 drivers/media/platform/synopsys/Makefile
>   create mode 100644 drivers/media/platform/synopsys/hdmirx/Kconfig
>   create mode 100644 drivers/media/platform/synopsys/hdmirx/Makefile
>   create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx.c
>   create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx.h
>   create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx_cec.c
>   create mode 100644 drivers/media/platform/synopsys/hdmirx/snps_hdmirx_cec.h
> 
...
> diff --git a/drivers/media/platform/synopsys/hdmirx/snps_hdmirx.c b/drivers/media/platform/synopsys/hdmirx/snps_hdmirx.c
> new file mode 100644
> index 000000000000..1dfecf256393
> --- /dev/null
> +++ b/drivers/media/platform/synopsys/hdmirx/snps_hdmirx.c
> @@ -0,0 +1,2763 @@
> +// SPDX-License-Identifier: GPL-2.0
> +/*

...

> +}
> +
> +static int hdmirx_probe(struct platform_device *pdev)
> +{
> +	struct snps_hdmirx_dev *hdmirx_dev;
> +	struct device *dev = &pdev->dev;
> +	struct v4l2_ctrl_handler *hdl;
> +	struct hdmirx_stream *stream;
> +	struct v4l2_device *v4l2_dev;
> +	int ret;
> +
> +	hdmirx_dev = devm_kzalloc(dev, sizeof(*hdmirx_dev), GFP_KERNEL);
> +	if (!hdmirx_dev)
> +		return -ENOMEM;
> +
> +	ret = dma_coerce_mask_and_coherent(dev, DMA_BIT_MASK(32));
> +	if (ret)
> +		return ret;
> +
> +	hdmirx_dev->dev = dev;
> +	dev_set_drvdata(dev, hdmirx_dev);
> +
> +	ret = hdmirx_parse_dt(hdmirx_dev);
> +	if (ret)
> +		return ret;
> +
> +	ret = hdmirx_setup_irq(hdmirx_dev, pdev);
> +	if (ret)
> +		return ret;
> +
> +	hdmirx_dev->regs = devm_platform_ioremap_resource(pdev, 0);
> +	if (IS_ERR(hdmirx_dev->regs))
> +		return dev_err_probe(dev, PTR_ERR(hdmirx_dev->regs),
> +				     "failed to remap regs resource\n");
> +
> +	mutex_init(&hdmirx_dev->stream_lock);
> +	mutex_init(&hdmirx_dev->work_lock);


AFAIK there's no unified opinion on droping mutex_destroy.
Is it so accepted in media subsystem or should we used devm_mutex_init?


 > +	spin_lock_init(&hdmirx_dev->rst_lock);
 > +
 > +	init_completion(&hdmirx_dev->cr_write_done);
 > +	init_completion(&hdmirx_dev->timer_base_lock);
 > +	init_completion(&hdmirx_dev->avi_pkt_rcv);
 > +
 > +	INIT_WORK(&hdmirx_dev->work_wdt_config, hdmirx_work_wdt_config);
 > +	INIT_DELAYED_WORK(&hdmirx_dev->delayed_work_hotplug,
 > +			  hdmirx_delayed_work_hotplug);
 > +	INIT_DELAYED_WORK(&hdmirx_dev->delayed_work_res_change,
 > +			  hdmirx_delayed_work_res_change);
 > +	INIT_DELAYED_WORK(&hdmirx_dev->delayed_work_heartbeat,
 > +			  hdmirx_delayed_work_heartbeat);
 > +
 > +	hdmirx_dev->cur_fmt_fourcc = V4L2_PIX_FMT_BGR24;
 > +	hdmirx_dev->timings = cea640x480;
 > +
 > +	hdmirx_enable(dev);
 > +	hdmirx_init(hdmirx_dev);
 > +
 > +	v4l2_dev = &hdmirx_dev->v4l2_dev;
 > +	strscpy(v4l2_dev->name, dev_name(dev), sizeof(v4l2_dev->name));
 > +
 > +	hdl = &hdmirx_dev->hdl;
 > +	v4l2_ctrl_handler_init(hdl, 1);
 > +
 > +	hdmirx_dev->detect_tx_5v_ctrl = v4l2_ctrl_new_std(hdl, NULL,
 > +							  V4L2_CID_DV_RX_POWER_PRESENT,
 > +							  0, 1, 0, 0);
 > +
 > +	hdmirx_dev->rgb_range = v4l2_ctrl_new_std_menu(hdl, 0,
 > +						       V4L2_CID_DV_RX_RGB_RANGE,
 > +						       V4L2_DV_RGB_RANGE_FULL, 0,
 > +						       V4L2_DV_RGB_RANGE_AUTO);
 > +
 > +	hdmirx_dev->rgb_range->flags |= V4L2_CTRL_FLAG_READ_ONLY;
 > +
 > +	if (hdl->error) {
 > +		dev_err(dev, "v4l2 ctrl handler init failed\n");
 > +		ret = hdl->error;
 > +		goto err_pm;
 > +	}
 > +	hdmirx_dev->v4l2_dev.ctrl_handler = hdl;
 > +
 > +	ret = v4l2_device_register(dev, &hdmirx_dev->v4l2_dev);
 > +	if (ret < 0) {
 > +		dev_err(dev, "register v4l2 device failed\n");
 > +		goto err_hdl;
 > +	}
 > +
 > +	stream = &hdmirx_dev->stream;
 > +	stream->hdmirx_dev = hdmirx_dev;
 > +	ret = hdmirx_register_stream_vdev(stream);
 > +	if (ret < 0) {
 > +		dev_err(dev, "register video device failed\n");
 > +		goto err_unreg_v4l2_dev;
 > +	}
 > +
 > +	ret = hdmirx_register_cec(hdmirx_dev, pdev);
 > +	if (ret)
 > +		goto err_unreg_video_dev;
 > +
 > +	hdmirx_load_default_edid(hdmirx_dev);
 > +
 > +	hdmirx_enable_irq(dev);
 > +
 > +	return 0;
 > +
 > +err_unreg_video_dev:
 > +	video_unregister_device(&hdmirx_dev->stream.vdev);
 > +err_unreg_v4l2_dev:
 > +	v4l2_device_unregister(&hdmirx_dev->v4l2_dev);
 > +err_hdl:
 > +	v4l2_ctrl_handler_free(&hdmirx_dev->hdl);
 > +err_pm:
 > +	hdmirx_disable(dev);
 > +
 > +	return ret;
 > +}

...

-- 
Best regards
George



More information about the Linux-rockchip mailing list