[PATCH 2/8] arm64: dts: rockchip: enable second PCIe controller on the Qnap-TS433

[Heiko Stuebner]

The TS433 uses both pcie controllers for sata and the 2nd network
interface. Set the needed data-lanes in the pcie3 phy and enable
the second pcie controller, as well as remove the bifurcation comment.

Signed-off-by: Heiko Stuebner <heiko at sntech.de>
---
 arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts | 9 ++++++++-
 1 file changed, 8 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts b/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
index 889838b4079ae..0636a08986572 100644
--- a/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3568-qnap-ts433.dts
@@ -78,16 +78,23 @@ rgmii_phy0: ethernet-phy at 0 {
 };
 
 &pcie30phy {
+	data-lanes = <1 2>;
 	status = "okay";
 };
 
 &pcie3x1 {
-	/* The downstream dts has: rockchip,bifurcation, XXX: find out what this is about */
 	reset-gpios = <&gpio0 RK_PC7 GPIO_ACTIVE_HIGH>;
 	vpcie3v3-supply = <&vcc3v3_pcie>;
 	status = "okay";
 };
 
+&pcie3x2 {
+	num-lanes = <1>;
+	reset-gpios = <&gpio2 RK_PD6 GPIO_ACTIVE_HIGH>;
+	vpcie3v3-supply = <&vcc3v3_pcie>;
+	status = "okay";
+};
+
 &sdhci {
 	bus-width = <8>;
 	max-frequency = <200000000>;
-- 
2.39.2