[PATCH v3 3/5] arm64: dts: rockchip: Add AP6275P wireless support to Khadas Edge 2

[Krzysztof Kozlowski]

On 01/07/2024 13:31, Jacobe Zang wrote:
>>>> +     pcie at 0,0 {
>>>> +             reg = <0x400000 0 0 0 0>;
>>>> +             #address-cells = <3>;
>>>> +             #size-cells = <2>;
>>>> +             ranges;
>>>> +             device_type = "pci";
>>>> +             bus-range = <0x40 0x4f>;
>>>> +
>>>> +             wifi: wifi at 0,0 {
>>> Where is the compatible (again!)? Test your code - you will see your
>>> binding is a no-op.
>>
>> I tried to build kernel with CHECK_DTBS=1. And didn't get any message
>> like 'compatible' is a required property in wifi node. But when I check
>> the bindings that do required the compatible... So I will add it next time.
> 
>> Yep, use different clock name and then test. You should see errors,
>> right? But there are not, because schema is not applied to this node at all.
>>
>> Look how Apple is doing this.
>>
>> I have doubts that your code works at all in the first place. If there
>> is no compatible, how your platform device gets of_node?
> 
> In file brcm_hw_ids.h and pcie.c has added Device ID and Vendor ID
> for bus to enumerate the device when board bootup, so I didn't add
> specific compatible in DTS. And by doing so, it can probe successfully.

I did not ask about probe()... that's quite obvious. How the device's
of_node is assigned?

Best regards,
Krzysztof