[PATCH] soc: rockchip: grf: Fix SDMMC not working on RK3588 with bus-width > 1

Kever Yang kever.yang at rock-chips.com
Thu Jan 25 18:56:42 PST 2024


Hi Ondrej,

On 2023/6/19 09:09, Ondřej Jirman wrote:
> From: Ondrej Jirman <megi at xff.cz>
>
> RK3588 has the same issue as other earlier RK SoCs. JTAG
> functionality muxed to some SDMMC data pins causes issues with SDMMC
> interface. Without this patch, I can only use SDMMC inteface
> with bus-width = <1>. (JTAG is muxed to data pins D2 and D3)
Which board did you met this issue?

The force jtag function should be work if all the iomux and hardware 
setting is corret:
     All the IO for SDMMC signal including SDMMC_DET, should set the 
iomux/pinctrl to mmc function
instead of GPIO function.

Seems like you are working on rk3588-quartzpro64, when I check its dts, 
I found below setting in sdmmc node:
cd-gpios = <&gpio0 RK_PA4 GPIO_ACTIVE_LOW>;
Since quartzpro64 is using the correct IO and there is already a 
&sdmmc_det in sdmmc node,
you don't need to overwrite it with "cd-gpios".

Could you help to revert this patch and remove "cd-gpios" in dts sdmmc, 
and test sdmmc function again?
It should work with SD card 4 line mode and force jtag available when 
people need it.

Thanks,
- Kever
>
> Signed-off-by: Ondrej Jirman <megi at xff.cz>
> ---
>   drivers/soc/rockchip/grf.c | 14 ++++++++++++++
>   1 file changed, 14 insertions(+)
>
> diff --git a/drivers/soc/rockchip/grf.c b/drivers/soc/rockchip/grf.c
> index 15a3970e3509..d768c5a70174 100644
> --- a/drivers/soc/rockchip/grf.c
> +++ b/drivers/soc/rockchip/grf.c
> @@ -121,6 +121,17 @@ static const struct rockchip_grf_info rk3566_pipegrf __initconst = {
>   	.num_values = ARRAY_SIZE(rk3566_defaults),
>   };
>   
> +#define RK3588_GRF_SOC_CON6		0x0318
> +
> +static const struct rockchip_grf_value rk3588_defaults[] __initconst = {
> +	{ "jtag switching", RK3588_GRF_SOC_CON6, HIWORD_UPDATE(0, 1, 14) },
> +};
> +
> +static const struct rockchip_grf_info rk3588_sysgrf __initconst = {
> +	.values = rk3588_defaults,
> +	.num_values = ARRAY_SIZE(rk3588_defaults),
> +};
> +
>   
>   static const struct of_device_id rockchip_grf_dt_match[] __initconst = {
>   	{
> @@ -147,6 +158,9 @@ static const struct of_device_id rockchip_grf_dt_match[] __initconst = {
>   	}, {
>   		.compatible = "rockchip,rk3566-pipe-grf",
>   		.data = (void *)&rk3566_pipegrf,
> +	}, {
> +		.compatible = "rockchip,rk3588-sys-grf",
> +		.data = (void *)&rk3588_sysgrf,
>   	},
>   	{ /* sentinel */ },
>   };



More information about the Linux-rockchip mailing list