[PATCH] arm64: dts: rockchip: add attiny_rst_gate to Ringneck

[Jakob Unterwurzacher]

Ringneck v1.4 can contain (placement option) an on-board ATtiny
microcontroller instead of an STM32. In normal operation, this
is transparent to the software, as both microcontrollers emulate
the same ICs (amc6821 and isl1208).

For flashing the ATtiny, the SWITCH_REG1 regulator of the board's PMIC is
used to enable the ATtiny UPDI debug interface. If the STM32 is placed, or if
we are running on an older Ringneck revision, SWITCH_REG1 is not connected
and has no effect.

Add attiny-updi-gate-regulator so userspace can control it via sysfs:

  echo enabled > /sys/devices/platform/attiny-updi-gate-regulator/state

Signed-off-by: Jakob Unterwurzacher <jakob.unterwurzacher at theobroma-systems.com>
---
 arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi | 12 ++++++++++++
 1 file changed, 12 insertions(+)

diff --git a/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi b/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi
index dec29a75d361..1f7f4b2ea66a 100644
--- a/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi
+++ b/arch/arm64/boot/dts/rockchip/px30-ringneck.dtsi
@@ -15,6 +15,12 @@ aliases {
 		rtc1 = &rk809;
 	};
 
+	/* allows userspace to control the gate of the ATtiny UPDI pass FET via sysfs */
+	attiny-updi-gate-regulator {
+		compatible = "regulator-output";
+		vout-supply = <&vg_attiny_updi>;
+	};
+
 	emmc_pwrseq: emmc-pwrseq {
 		compatible = "mmc-pwrseq-emmc";
 		pinctrl-0 = <&emmc_reset>;
@@ -146,6 +152,7 @@ rk809: pmic at 20 {
 		vcc5-supply = <&vcc_3v3>;
 		vcc6-supply = <&vcc_3v3>;
 		vcc7-supply = <&vcc_3v3>;
+		vcc8-supply = <&vcc5v0_sys>;
 		vcc9-supply = <&vcc5v0_sys>;
 
 		regulators {
@@ -290,6 +297,11 @@ regulator-state-mem {
 					regulator-suspend-microvolt = <1800000>;
 				};
 			};
+
+			/* supplies the gate of the ATtiny UPDI pass FET */
+			vg_attiny_updi: SWITCH_REG1 {
+				regulator-name = "vg_attiny_updi";
+			};
 		};
 	};
 };
-- 
2.43.0