[PATCH v5 13/14] PCI: rockchip-ep: Handle PERST# signal in endpoint mode
Damien Le Moal
dlemoal at kernel.org
Sat Dec 14 18:09:49 PST 2024
On 12/15/24 09:13, Bjorn Helgaas wrote:
> On Thu, Oct 17, 2024 at 10:58:48AM +0900, Damien Le Moal wrote:
>> Currently, the Rockchip PCIe endpoint controller driver does not handle
>> the PERST# signal, which prevents detecting when link training should
>> actually be started or if the host resets the device. This however can
>> be supported using the controller reset_gpios property set as an input
>> GPIO for endpoint mode.
>
>> @@ -50,6 +51,9 @@ struct rockchip_pcie_ep {
>> u64 irq_pci_addr;
>> u8 irq_pci_fn;
>> u8 irq_pending;
>> + int perst_irq;
>> + bool perst_asserted;
>> + bool link_up;
>> struct delayed_work link_training;
>> };
>
> I should have caught this last cycle, but just noticed this:
>
> $ make W=1 -k drivers/pci/ drivers/misc/pci_*
> ...
> CC drivers/pci/controller/pcie-rockchip-ep.o
> drivers/pci/controller/pcie-rockchip-ep.c:59: warning: Function parameter or struct member 'perst_irq' not described in 'rockchip_pcie_ep'
> drivers/pci/controller/pcie-rockchip-ep.c:59: warning: Function parameter or struct member 'perst_asserted' not described in 'rockchip_pcie_ep'
> drivers/pci/controller/pcie-rockchip-ep.c:59: warning: Function parameter or struct member 'link_up' not described in 'rockchip_pcie_ep'
> drivers/pci/controller/pcie-rockchip-ep.c:59: warning: Function parameter or struct member 'link_training' not described in 'rockchip_pcie_ep'
Oops... Sending a fix.
--
Damien Le Moal
Western Digital Research
More information about the Linux-rockchip
mailing list