[PATCH v5 6/7] arm64: dts: rockchip: enable USB-C on NanoPC-T6

[Marcin Juszkiewicz]

Enable the USB-C port on FriendlyELEC NanoPC-T6.

Works one way so far but still better than before.

Signed-off-by: Marcin Juszkiewicz <marcin.juszkiewicz at linaro.org>
---
 arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi | 76 ++++++++++++++++++++--
 1 file changed, 72 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi b/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi
index 465d294703f5..399cc59320d1 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3588-nanopc-t6.dtsi
@@ -137,6 +137,8 @@ vbus5v0_typec: vbus5v0-typec-regulator {
 		gpio = <&gpio1 RK_PD2 GPIO_ACTIVE_HIGH>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&typec5v_pwren>;
+		regulator-always-on;
+		regulator-boot-on;
 		regulator-name = "vbus5v0_typec";
 		regulator-min-microvolt = <5000000>;
 		regulator-max-microvolt = <5000000>;
@@ -381,11 +383,34 @@ connector {
 			compatible = "usb-c-connector";
 			data-role = "dual";
 			label = "USB-C";
-			power-role = "dual";
-			try-power-role = "sink";
+			power-role = "source";
 			source-pdos = <PDO_FIXED(5000, 2000, PDO_FIXED_USB_COMM)>;
-			sink-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>;
-			op-sink-microwatt = <1000000>;
+
+			ports {
+				#address-cells = <1>;
+				#size-cells = <0>;
+
+				port at 0 {
+					reg = <0>;
+					usbc0_hs: endpoint {
+						remote-endpoint = <&usb_host0_xhci_drd_sw>;
+					};
+				};
+
+				port at 1 {
+					reg = <1>;
+					usbc0_ss: endpoint {
+						remote-endpoint = <&usbdp_phy0_typec_ss>;
+					};
+				};
+
+				port at 2 {
+					reg = <2>;
+					usbc0_sbu: endpoint {
+						remote-endpoint = <&usbdp_phy0_typec_sbu>;
+					};
+				};
+			};
 		};
 	};
 
@@ -928,6 +953,14 @@ &uart2 {
 	status = "okay";
 };
 
+&u2phy0 {
+	status = "okay";
+};
+
+&u2phy0_otg {
+	status = "okay";
+};
+
 &u2phy2_host {
 	phy-supply = <&vdd_4g_3v3>;
 	status = "okay";
@@ -945,6 +978,29 @@ &u2phy3 {
 	status = "okay";
 };
 
+&usbdp_phy0 {
+	mode-switch;
+	orientation-switch;
+	sbu1-dc-gpios = <&gpio4 RK_PA6 GPIO_ACTIVE_HIGH>;
+	sbu2-dc-gpios = <&gpio4 RK_PA7 GPIO_ACTIVE_HIGH>;
+	status = "okay";
+
+	port {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		usbdp_phy0_typec_ss: endpoint at 0 {
+			reg = <0>;
+			remote-endpoint = <&usbc0_ss>;
+		};
+
+		usbdp_phy0_typec_sbu: endpoint at 1 {
+			reg = <1>;
+			remote-endpoint = <&usbc0_sbu>;
+		};
+	};
+};
+
 &usb_host0_ehci {
 	status = "okay";
 };
@@ -953,6 +1009,18 @@ &usb_host0_ohci {
 	status = "okay";
 };
 
+&usb_host0_xhci {
+	dr_mode = "host";
+	status = "okay";
+	usb-role-switch;
+
+	port {
+		usb_host0_xhci_drd_sw: endpoint {
+			remote-endpoint = <&usbc0_hs>;
+		};
+	};
+};
+
 &usb_host1_ehci {
 	status = "okay";
 };

-- 
2.46.0