[PATCH 2/7] dt-bindings: i2c: mux: mule: add dt-bindings for mule i2c multiplexer

Krzysztof Kozlowski krzysztof.kozlowski at linaro.org
Sun Apr 28 23:27:44 PDT 2024


Except that this was not fully tested few comments.

A nit, subject: drop second/last, redundant "dt-bindings for". The
"dt-bindings" prefix is already stating that these are bindings.
See also:
https://elixir.bootlin.com/linux/v6.7-rc8/source/Documentation/devicetree/bindings/submitting-patches.rst#L18


On 26/04/2024 18:49, Farouk Bouabid wrote:
> This patch adds support for the Mule I2C multiplexer.

Please do not use "This commit/patch/change", but imperative mood. See
longer explanation here:
https://elixir.bootlin.com/linux/v5.17.1/source/Documentation/process/submitting-patches.rst#L95

> 
> Mule is an mcu that emulates a set of i2c devices which are reacheable
> through an i2c-mux.
> 
> The emulated devices share a single i2c address with the mux itself where
> the requested register is what determines which logic is executed (mux or
> device).
> 
> Signed-off-by: Farouk Bouabid <farouk.bouabid at theobroma-systems.com>
> ---
>  .../devicetree/bindings/i2c/i2c-mux-mule.yaml      | 80 ++++++++++++++++++++++
>  1 file changed, 80 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/i2c/i2c-mux-mule.yaml b/Documentation/devicetree/bindings/i2c/i2c-mux-mule.yaml
> new file mode 100644
> index 000000000000..458e4661cbc8
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/i2c/i2c-mux-mule.yaml

Use compatible as filename.

> @@ -0,0 +1,80 @@
> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
> +%YAML 1.2
> +---
> +$id: http://devicetree.org/schemas/i2c/i2c-mux-mule.yaml#
> +$schema: http://devicetree.org/meta-schemas/core.yaml#
> +
> +title: Mule I2C multiplexer
> +
> +maintainers:
> +  - Farouk Bouabid <farouk.bouabid at theobroma-systems.com>
> +  - Quentin Schulz <quentin.schulz at theobroma-systems.com>
> +
> +description: |
> +  Mule is an mcu that emulates a set of i2c devices which are reacheable

typo, reachable

> +  through an i2c-mux.
> +
> +  The emulated devices share a single i2c address with the mux itself where
> +  the requested register is what determines which logic is executed (mux or
> +  device)
> +
> +      +--------------------------------------------------+
> +      | Mule                                             |
> +      |    +---------------+                             |
> +  ------+->|Config register|----+                        |
> +      | |  +---------------+    |                        |
> +      | |                       V_                       |
> +      | |                      |  \          +--------+  |
> +      | |                      |   \-------->| dev #0 |  |
> +      | |                      |   |         +--------+  |
> +      | |                      | M |-------->| dev #1 |  |
> +      | +--------------------->| U |         +--------+  |
> +      |                        | X |-------->| dev #2 |  |
> +      |                        |   |         +--------+  |
> +      |                        |   /-------->| dev #3 |  |
> +      |                        |__/          +--------+  |
> +      +--------------------------------------------------+
> +
> +
> +allOf:
> +  - $ref: /schemas/i2c/i2c-mux.yaml#
> +
> +properties:
> +  compatible:
> +    const: tsd,mule-i2c-mux
> +
> +  reg:
> +    maxItems: 1
> +

Best regards,
Krzysztof




More information about the Linux-rockchip mailing list