[PATCH V3 3/6] nv3051d: Add Powkiddy RK2023 Panel Support

[Chris Morgan]

From: Chris Morgan <macromorgan at hotmail.com>

Refactor the driver to add support for the powkiddy,rk2023-panel
panel. This panel is extremely similar to the rg353p-panel but
requires a smaller vertical back porch and isn't as tolerant of
higher speeds. Note that while all of these panels are identical in
size (70x57) it is possible future panels may not be.

Tested on my RG351V, RG353P, RG353V, and RK2023.

Signed-off-by: Chris Morgan <macromorgan at hotmail.com>
---
 .../gpu/drm/panel/panel-newvision-nv3051d.c   | 55 +++++++++++++++----
 1 file changed, 44 insertions(+), 11 deletions(-)

diff --git a/drivers/gpu/drm/panel/panel-newvision-nv3051d.c b/drivers/gpu/drm/panel/panel-newvision-nv3051d.c
index c44c6945662f..94d89ffd596b 100644
--- a/drivers/gpu/drm/panel/panel-newvision-nv3051d.c
+++ b/drivers/gpu/drm/panel/panel-newvision-nv3051d.c
@@ -28,6 +28,7 @@ struct nv3051d_panel_info {
 	unsigned int num_modes;
 	u16 width_mm, height_mm;
 	u32 bus_flags;
+	u32 mode_flags;
 };
 
 struct panel_nv3051d {
@@ -387,15 +388,7 @@ static int panel_nv3051d_probe(struct mipi_dsi_device *dsi)
 
 	dsi->lanes = 4;
 	dsi->format = MIPI_DSI_FMT_RGB888;
-	dsi->mode_flags = MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_VIDEO_BURST |
-			  MIPI_DSI_MODE_LPM | MIPI_DSI_MODE_NO_EOT_PACKET;
-
-	/*
-	 * The panel in the RG351V is identical to the 353P, except it
-	 * requires MIPI_DSI_CLOCK_NON_CONTINUOUS to operate correctly.
-	 */
-	if (of_device_is_compatible(dev->of_node, "anbernic,rg351v-panel"))
-		dsi->mode_flags |= MIPI_DSI_CLOCK_NON_CONTINUOUS;
+	dsi->mode_flags = ctx->panel_info->mode_flags;
 
 	drm_panel_init(&ctx->panel, &dsi->dev, &panel_nv3051d_funcs,
 		       DRM_MODE_CONNECTOR_DSI);
@@ -483,16 +476,56 @@ static const struct drm_display_mode nv3051d_rgxx3_modes[] = {
 	},
 };
 
-static const struct nv3051d_panel_info nv3051d_rgxx3_info = {
+static const struct drm_display_mode nv3051d_rk2023_modes[] = {
+	{
+		.hdisplay       = 640,
+		.hsync_start    = 640 + 40,
+		.hsync_end      = 640 + 40 + 2,
+		.htotal         = 640 + 40 + 2 + 80,
+		.vdisplay       = 480,
+		.vsync_start    = 480 + 18,
+		.vsync_end      = 480 + 18 + 2,
+		.vtotal         = 480 + 18 + 2 + 4,
+		.clock          = 24150,
+		.flags          = DRM_MODE_FLAG_NHSYNC | DRM_MODE_FLAG_NVSYNC,
+	},
+};
+
+static const struct nv3051d_panel_info nv3051d_rg351v_info = {
 	.display_modes = nv3051d_rgxx3_modes,
 	.num_modes = ARRAY_SIZE(nv3051d_rgxx3_modes),
 	.width_mm = 70,
 	.height_mm = 57,
 	.bus_flags = DRM_BUS_FLAG_DE_LOW | DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE,
+	.mode_flags = MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_VIDEO_BURST |
+		      MIPI_DSI_MODE_LPM | MIPI_DSI_MODE_NO_EOT_PACKET |
+		      MIPI_DSI_CLOCK_NON_CONTINUOUS,
+};
+
+static const struct nv3051d_panel_info nv3051d_rg353p_info = {
+	.display_modes = nv3051d_rgxx3_modes,
+	.num_modes = ARRAY_SIZE(nv3051d_rgxx3_modes),
+	.width_mm = 70,
+	.height_mm = 57,
+	.bus_flags = DRM_BUS_FLAG_DE_LOW | DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE,
+	.mode_flags = MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_VIDEO_BURST |
+		      MIPI_DSI_MODE_LPM | MIPI_DSI_MODE_NO_EOT_PACKET,
+};
+
+static const struct nv3051d_panel_info nv3051d_rk2023_info = {
+	.display_modes = nv3051d_rk2023_modes,
+	.num_modes = ARRAY_SIZE(nv3051d_rk2023_modes),
+	.width_mm = 70,
+	.height_mm = 57,
+	.bus_flags = DRM_BUS_FLAG_DE_LOW | DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE,
+	.mode_flags = MIPI_DSI_MODE_VIDEO | MIPI_DSI_MODE_VIDEO_BURST |
+		      MIPI_DSI_MODE_LPM | MIPI_DSI_MODE_NO_EOT_PACKET,
 };
 
 static const struct of_device_id newvision_nv3051d_of_match[] = {
-	{ .compatible = "newvision,nv3051d", .data = &nv3051d_rgxx3_info },
+	{ .compatible = "anbernic,rg351v-panel", .data = &nv3051d_rg351v_info },
+	{ .compatible = "anbernic,rg353p-panel", .data = &nv3051d_rg353p_info },
+	{ .compatible = "powkiddy,rk2023-panel", .data = &nv3051d_rk2023_info },
 	{ /* sentinel */ }
 };
 MODULE_DEVICE_TABLE(of, newvision_nv3051d_of_match);
-- 
2.34.1