[PATCH 1/7] iio: adc: rockchip_saradc: Add support for RK3588

[AngeloGioacchino Del Regno]

Il 17/05/23 01:00, Shreeya Patel ha scritto:
> Refactor conversion operation to support rk3588 saradc and
> add separate start, read, powerdown in respective hooks.
> 
> Signed-off-by: Simon Xue <xxm at rock-chips.com>
> Signed-off-by: Shreeya Patel <shreeya.patel at collabora.com>
> ---
>   drivers/iio/adc/rockchip_saradc.c | 127 +++++++++++++++++++++++++++---
>   1 file changed, 115 insertions(+), 12 deletions(-)
> 
> diff --git a/drivers/iio/adc/rockchip_saradc.c b/drivers/iio/adc/rockchip_saradc.c
> index 79448c5ffc2a..ac6fdf8e673b 100644
> --- a/drivers/iio/adc/rockchip_saradc.c
> +++ b/drivers/iio/adc/rockchip_saradc.c
> @@ -38,10 +38,29 @@
>   #define SARADC_TIMEOUT			msecs_to_jiffies(100)
>   #define SARADC_MAX_CHANNELS		8
>   
> +/* v2 registers */
> +#define SARADC2_CONV_CON		0x0
> +#define SARADC_T_PD_SOC			0x4
> +#define SARADC_T_DAS_SOC		0xc
> +#define SARADC2_END_INT_EN		0x104
> +#define SARADC2_ST_CON			0x108
> +#define SARADC2_STATUS			0x10c
> +#define SARADC2_END_INT_ST		0x110
> +#define SARADC2_DATA_BASE		0x120
> +
> +#define SARADC2_EN_END_INT		BIT(0)
> +#define SARADC2_START			BIT(4)
> +#define SARADC2_SINGLE_MODE		BIT(5)
> +
> +struct rockchip_saradc;
> +
>   struct rockchip_saradc_data {
>   	const struct iio_chan_spec	*channels;
>   	int				num_channels;
>   	unsigned long			clk_rate;
> +	void (*start)(struct rockchip_saradc *info, int chn);
> +	int (*read)(struct rockchip_saradc *info);
> +	void (*power_down)(struct rockchip_saradc *info);
>   };
>   
>   struct rockchip_saradc {
> @@ -60,27 +79,77 @@ struct rockchip_saradc {
>   	struct notifier_block nb;
>   };
>   
> -static void rockchip_saradc_power_down(struct rockchip_saradc *info)
> +static void rockchip_saradc_reset_controller(struct reset_control *reset);
> +
> +static void rockchip_saradc_start_v1(struct rockchip_saradc *info, int chn)
> +{
> +	/* 8 clock periods as delay between power up and start cmd */
> +	writel_relaxed(8, info->regs + SARADC_DLY_PU_SOC);
> +	/* Select the channel to be used and trigger conversion */
> +	writel(SARADC_CTRL_POWER_CTRL | (chn & SARADC_CTRL_CHN_MASK) |
> +	       SARADC_CTRL_IRQ_ENABLE, info->regs + SARADC_CTRL);
> +}
> +
> +static void rockchip_saradc_start_v2(struct rockchip_saradc *info, int chn)
> +{
> +	int val;
> +
> +	if (info->reset)
> +		rockchip_saradc_reset_controller(info->reset);
> +
> +	writel_relaxed(0xc, info->regs + SARADC_T_DAS_SOC);
> +	writel_relaxed(0x20, info->regs + SARADC_T_PD_SOC);
> +	val = SARADC2_EN_END_INT << 16 | SARADC2_EN_END_INT;

What about using bitfield macros?

/* "LO" and "HI" may get a better name, if there's any possible one! */
#define SARADC2_EN_END_INT_LO BIT(0)
#define SARADC2_EN_END_INT_HI BIT(16)

val = FIELD_PREP(SARADC_EN_END_INT_LO, 1);
val |= FIELD_PREP(SARADC_EN_END_INT_HI, 1);
writel ....

Otherwise, if it's about two really "specular" instances, you can probably
keep the current definition as SARADC2_EN_END_INT and do

val = FIELD_PREP(SARADC_EN_END_INT, 1);
val |= val << 16;
writel ...

/* note: high, low bits are unknown to me, I assumed it's 16 bits :-) */
#define SARADC2_CONV_CHANNELS GENMASK(15, 0)

val = FIELD_PREP(SARADC2_START, 1);
val |= FIELD_PREP(SARADC2_SINGLE_MODE, 1);
val |= FIELD_PREP(SARADC2_CONV_CHANNELS, chn);
val |= val << 16;
writel ...


> +	writel_relaxed(val, info->regs + SARADC2_END_INT_EN);
> +	val = SARADC2_START | SARADC2_SINGLE_MODE | chn;
> +	writel(val << 16 | val, info->regs + SARADC2_CONV_CON);
> +}
> +

Cheers,
Angelo