[PATCH 2/3] dt-bindings: backlight: lm3630a: add entries to control boost frequency

Krzysztof Kozlowski krzysztof.kozlowski at linaro.org
Sat Jun 17 03:12:17 PDT 2023


On 14/06/2023 21:08, Maximilian Weigand wrote:
> From: Maximilian Weigand <mweigand at mweigand.net>
> 
> Add 'ti,boost_use_1mhz' to switch between 500 kHz and 1 MHz boost
> converter switching frequency, and add 'ti,boost_frequency_shift' to
> activate a frequency shift to 560 kHz or 1.12 MHz, respectively.
> 
> Signed-off-by: Maximilian Weigand <mweigand at mweigand.net>
> ---
>  .../bindings/leds/backlight/lm3630a-backlight.yaml           | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml b/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml
> index 3c9b4054ed9a..ef7ea0ad2d25 100644
> --- a/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml
> +++ b/Documentation/devicetree/bindings/leds/backlight/lm3630a-backlight.yaml
> @@ -33,6 +33,18 @@ properties:
>      description: GPIO to use to enable/disable the backlight (HWEN pin).
>      maxItems: 1
>  
> +  ti,boost_use_1mhz:

No underscores in property names.

> +    description: |

Do not need '|' unless you need to preserve formatting.

> +      If present, change the boost converter switching frequency from the
> +      default 500 kHz to 1 MHz. Refer to data sheet for hardware requirements.
> +    type: boolean
> +
> +  ti,boost_frequency_shift:
> +    description: |
> +      If present, change boost converter switching frequency from 500 kHz to
> +      560 kHz or from 1 Mhz to 1.12 Mhz, respectively.

So just make it a property choosing the frequency, not bools, with
proper unit suffix.


Best regards,
Krzysztof




More information about the Linux-rockchip mailing list