[PATCH] arm64: dts: rockchip: add rk3566 audio nodes

[Furkan Kardame]

This patch adds simple audio card nodes
Enabled i2s0_8ch as it is needed for hdmi audio
Added i2s1_8ch as it is needed for 3.5mm audio jack

Signed-off-by: Furkan Kardame <f.kardame at manjaro.org>
---
 .../arm64/boot/dts/rockchip/rk3566-roc-pc.dts | 60 ++++++++++++++++++-
 1 file changed, 58 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts b/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts
index 61c7a3ad7..793d07f0c 100644
--- a/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts
@@ -39,6 +39,28 @@ hdmi_con_in: endpoint {
 		};
 	};
 
+	i2s1_8ch: i2s at fe410000 {
+		compatible = "rockchip,rk3568-i2s-tdm";
+		reg = <0x0 0xfe410000 0x0 0x1000>;
+		interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>;
+		assigned-clocks = <&cru CLK_I2S1_8CH_TX_SRC>, <&cru CLK_I2S1_8CH_RX_SRC>;
+		assigned-clock-rates = <1188000000>, <1188000000>;
+		clocks = <&cru MCLK_I2S1_8CH_TX>, <&cru MCLK_I2S1_8CH_RX>,
+			 <&cru HCLK_I2S1_8CH>;
+		clock-names = "mclk_tx", "mclk_rx", "hclk";
+		dmas = <&dmac1 3>, <&dmac1 2>;
+		dma-names = "rx", "tx";
+		resets = <&cru SRST_M_I2S1_8CH_TX>, <&cru SRST_M_I2S1_8CH_RX>;
+		reset-names = "tx-m", "rx-m";
+		rockchip,grf = <&grf>;
+		pinctrl-names = "default";
+		pinctrl-0 = <&i2s1m0_sclktx &i2s1m0_sclkrx
+			     &i2s1m0_lrcktx &i2s1m0_lrckrx
+			     &i2s1m0_sdi0   &i2s1m0_sdo0>;
+		#sound-dai-cells = <0>;
+		status = "disabled";
+	};
+
 	leds {
 		compatible = "gpio-leds";
 
@@ -53,6 +75,22 @@ led-user {
 		};
 	};
 
+	rk809-sound {
+		compatible = "simple-audio-card";
+		simple-audio-card,format = "i2s";
+		simple-audio-card,name = "STATION-M2-FRONT";
+		simple-audio-card,mclk-fs = <256>;
+		status = "okay";
+
+		simple-audio-card,cpu {
+			sound-dai = <&i2s1_8ch>;
+		};
+
+		simple-audio-card,codec {
+			sound-dai = <&rk809>;
+		};
+	};
+
 	sdio_pwrseq: sdio-pwrseq {
 		status = "okay";
 		compatible = "mmc-pwrseq-simple";
@@ -226,9 +264,13 @@ rk809: pmic at 20 {
 		interrupt-parent = <&gpio0>;
 		interrupts = <RK_PA7 IRQ_TYPE_LEVEL_LOW>;
 		clock-output-names = "rk808-clkout1", "rk808-clkout2";
-
+		assigned-clocks = <&cru I2S1_MCLKOUT_TX>;
+		assigned-clock-parents = <&cru CLK_I2S1_8CH_TX>;
+		clock-names = "mclk";
+		clocks = <&cru I2S1_MCLKOUT_TX>;
+		pinctrl-0 = <&pmic_int>, <&i2s1m0_mclk>;
+		#sound-dai-cells = <0>;
 		pinctrl-names = "default";
-		pinctrl-0 = <&pmic_int>;
 		rockchip,system-power-controller;
 		wakeup-source;
 		#clock-cells = <1>;
@@ -435,6 +477,11 @@ vcc3v3_sd: SWITCH_REG2 {
 				regulator-boot-on;
 			};
 		};
+
+		codec {
+			mic-in-differential;
+		};
+
 	};
 };
 
@@ -452,6 +499,15 @@ &i2c3 {
 	status = "okay";
 };
 
+&i2s0_8ch {
+	status = "okay";
+};
+
+&i2s1_8ch {
+	rockchip,trcm-sync-tx-only;
+	status = "okay";
+};
+
 &mdio1 {
 	rgmii_phy1: ethernet-phy at 0 {
 		compatible = "ethernet-phy-ieee802.3-c22";
-- 
2.39.0