[RESEND PATCH] arm64: dts: rockchip: Fix eMMC Data Strobe PD

Heiko Stuebner heiko at sntech.de
Wed Dec 6 01:42:04 PST 2023


On Tue, 5 Dec 2023 12:29:00 -0800, Sam Edwards wrote:
> JEDEC standard JESD84-B51 defines the eMMC Data Strobe line, which is
> currently used only in HS400 mode, as a device->host clock signal that
> "is used only in read operation. The Data Strobe is always High-Z (not
> driven by the device and pulled down by RDS) or Driven Low in write
> operation, except during CRC status response." RDS is a pull-down
> resistor specified in the 10K-100K ohm range. Thus per the standard, the
> Data Strobe is always pulled to ground (by the eMMC and/or RDS) during
> write operations.
> 
> [...]

Applied, thanks!

[1/1] arm64: dts: rockchip: Fix eMMC Data Strobe PD
      commit: 37f3d6108730713c411827ab4af764909f4dfc78

Best regards,
-- 
Heiko Stuebner <heiko at sntech.de>



More information about the Linux-rockchip mailing list