[PATCH RFC v2 6/7] arm64: dts: qcom: fix touchscreen reset GPIO polarity

[Quentin Schulz]

From: Quentin Schulz <quentin.schulz at theobroma-systems.com>

The reset line is active low for the Goodix touchscreen controller so
let's fix the polarity in the Device Tree node.

Signed-off-by: Quentin Schulz <quentin.schulz at theobroma-systems.com>
---
Changes in v2:
- removed Qcom SC7180 Trogdor-based devices changes as they are not using this Goodix driver,

 arch/arm64/boot/dts/qcom/msm8998-fxtec-pro1.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/msm8998-fxtec-pro1.dts b/arch/arm64/boot/dts/qcom/msm8998-fxtec-pro1.dts
index 429ba57e20f71..8f738cade2652 100644
--- a/arch/arm64/boot/dts/qcom/msm8998-fxtec-pro1.dts
+++ b/arch/arm64/boot/dts/qcom/msm8998-fxtec-pro1.dts
@@ -249,7 +249,7 @@ touchscreen at 14 {
 		reg = <0x14>;
 		interrupt-parent = <&tlmm>;
 		interrupts = <125 IRQ_TYPE_LEVEL_LOW>;
-		reset-gpios = <&tlmm 89 GPIO_ACTIVE_HIGH>;
+		reset-gpios = <&tlmm 89 GPIO_ACTIVE_LOW>;
 		AVDD28-supply = <&vreg_l28_3p0>;
 		VDDIO-supply = <&ts_vio_vreg>;
 		pinctrl-names = "active";

-- 
b4 0.10.1