[PATCH] media: hantro: Use core-generated bus_info value

[Chen-Yu Tsai]

On Wed, Dec 21, 2022 at 3:39 AM Adam Ford <aford173 at gmail.com> wrote:
>
> On Fri, Dec 16, 2022 at 7:46 AM Chen-Yu Tsai <wenst at chromium.org> wrote:
> >
> > The Hantro driver uses a hardcoded value for the bus_info field in the
> > media device and |struct v4l2_capability|. This worked well when there
> > was just one device. However with the iMX.8 series we are now seeing
> > two Hantro blocks on the same chip. The static bus_info is no longer
> > sufficient for differentiating devices.
> >
> > Since commit f2d8b6917f3b ("media: v4l: ioctl: Set bus_info in
> > v4l_querycap()"), the V4L2 core provides a default value for the
> > bus_info field for platform and PCI devices. This value will match
> > the default value for media devices added by commit cef699749f37
> > ("media: mc: Set bus_info in media_device_init()"). These defaults
> > are stable and device-specific.
> >
> > Drop the static bus_info values from the hantro driver and use the
> > defaults.
> >
> > Signed-off-by: Chen-Yu Tsai <wenst at chromium.org>
> > ---
> >  arch/arm64/boot/dts/freescale/Makefile           | 1 +
> >  drivers/media/platform/verisilicon/hantro_drv.c  | 2 --
> >  drivers/media/platform/verisilicon/hantro_v4l2.c | 2 --
> >  3 files changed, 1 insertion(+), 4 deletions(-)
> >
> > diff --git a/arch/arm64/boot/dts/freescale/Makefile b/arch/arm64/boot/dts/freescale/Makefile
> > index ef6f364eaa18..ef815442c78b 100644
> > --- a/arch/arm64/boot/dts/freescale/Makefile
> > +++ b/arch/arm64/boot/dts/freescale/Makefile
> > @@ -55,6 +55,7 @@ dtb-$(CONFIG_ARCH_MXC) += imx8mm-data-modul-edm-sbc.dtb
> >  dtb-$(CONFIG_ARCH_MXC) += imx8mm-ddr4-evk.dtb
> >  dtb-$(CONFIG_ARCH_MXC) += imx8mm-emcon-avari.dtb
> >  dtb-$(CONFIG_ARCH_MXC) += imx8mm-evk.dtb
> > +dtb-$(CONFIG_ARCH_MXC) += imx8mm-hummingboard-pulse.dtb
>
> I think the makefile was edited by mistake.

It was. I'll send a v2.

On this topic though, has anyone else tried the i.MX8 Mini variant of
the Hummingboard Pulse?

I forward-ported the DT from SolidRun's 5.4 kernel and got it running
and correct to a certain degree, but if the PMIC regulator driver is
enabled, the board cuts out as soon as it is probed.


ChenYu