[PATCH v7 1/9] dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash controller

[Kever Yang]

Hi Rob,

On 2021/6/10 上午10:43, Rob Herring wrote:
> On Wed, Jun 09, 2021 at 10:04:04PM +0800, Jon Lin wrote:
>> From: Chris Morgan <macromorgan at hotmail.com>
>>
>> Add bindings for the Rockchip serial flash controller. New device
>> specific parameter of rockchip,sfc-no-dma included in documentation.
>>
>> Signed-off-by: Chris Morgan <macromorgan at hotmail.com>
>> Signed-off-by: Jon Lin <jon.lin at rock-chips.com>
>> ---
>>
>> Changes in v7:
>> - Fix up the sclk_sfc parent error in rk3036
>> - Unify to "rockchip,sfc" compatible id because all the feature update
>>    will have a new IP version, so the driver is used for the SFC IP in
>>    all SoCs
>> - Change to use node "sfc" to name the SFC pinctrl group
>> - Add subnode reg property check
>> - Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case
>> - Limit max_iosize to 32KB
>>
>> Changes in v6:
>> - Add support in device trees for rv1126(Declared in series 5 but not
>>    submitted)
>> - Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not
>>    affect interpretation and has been widely used
>> - Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted)
>> - Simplify the code, such as remove "rockchip_sfc_register_all"(Declared
>>    in series 5 but not submitted)
>> - Support SFC ver4 ver5(Declared in series 5 but not submitted)
>> - Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c
>> - Change to use devm_spi_alloc_master and spi_unregister_master
>>
>> Changes in v5:
>> - Add support in device trees for rv1126
>> - Support sfc tx_dual, tx_quad
>> - Simplify the code, such as remove "rockchip_sfc_register_all"
>> - Support SFC ver4 ver5
>>
>> Changes in v4:
>> - Changing patch back to an "RFC". An engineer from Rockchip
>>    reached out to me to let me know they are working on this patch for
>>    upstream, I am submitting this v4 for the community to see however
>>    I expect Jon Lin (jon.lin at rock-chips.com) will submit new patches
>>    soon and these are the ones we should pursue for mainlining. Jon's
>>    patch series should include support for more hardware than this
>>    series.
>> - Clean up documentation more and ensure it is correct per
>>    make dt_binding_check.
>> - Add support in device trees for rk3036, rk3308, and rv1108.
>> - Add ahb clock (hclk_sfc) support for rk3036.
>> - Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
>> - Change IRQ code to only mark IRQ as handled if it handles the
>>    specific IRQ (DMA transfer finish) it is supposed to handle.
>>
>> Changes in v3:
>> - Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
>> - Changed the compatible string from rockchip,sfc to
>>    rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
>>    driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
>>    RV1108 SoCs, and possibly more. However, I am currently only able
>>    to test this on a PX30 (an RK3326). The technical reference manuals
>>    appear to list the same registers for each device.
>> - Corrected devicetree documentation for formatting and to note these
>>    changes.
>> - Replaced the maintainer with Heiko Stuebner and myself, as we will
>>    take ownership of this going forward.
>> - Noted that the device (per the reference manual) supports 4 CS, but
>>    I am only able to test a single CS (CS 0).
>> - Reordered patches to comply with upstream rules.
>>
>> Changes in v2:
>> - Reimplemented driver using spi-mem subsystem.
>> - Removed power management code as I couldn't get it working properly.
>> - Added device tree bindings for Odroid Go Advance.
>>
>> Changes in v1:
>> hanges made in this new series versus the v8 of the old series:
>> - Added function to read spi-rx-bus-width from device tree, in the
>>    event that the SPI chip supports 4x mode but only has 2 pins
>>    wired (such as the Odroid Go Advance).
>> - Changed device tree documentation from txt to yaml format.
>> - Made "reset" message a dev_dbg from a dev_info.
>> - Changed read and write fifo functions to remove redundant checks.
>> - Changed the write and read from relaxed to non-relaxed when
>>    starting the DMA transfer or reading the DMA IRQ.
>> - Changed from dma_coerce_mask_and_coherent to just
>>    dma_set_mask_and_coherent.
>> - Changed name of get_if_type to rockchip_sfc_get_if_type.
>>
>>   .../devicetree/bindings/spi/rockchip-sfc.yaml | 88 +++++++++++++++++++
>>   1 file changed, 88 insertions(+)
>>   create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
>>
>> diff --git a/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
>> new file mode 100644
>> index 000000000000..42e4198e92af
>> --- /dev/null
>> +++ b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
>> @@ -0,0 +1,88 @@
>> +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
>> +%YAML 1.2
>> +---
>> +$id: http://devicetree.org/schemas/spi/rockchip-sfc.yaml#
>> +$schema: http://devicetree.org/meta-schemas/core.yaml#
>> +
>> +title: Rockchip Serial Flash Controller (SFC)
>> +
>> +maintainers:
>> +  - Heiko Stuebner <heiko at sntech.de>
>> +  - Chris Morgan <macromorgan at hotmail.com>
>> +
>> +allOf:
>> +  - $ref: spi-controller.yaml#
>> +
>> +properties:
>> +  compatible:
>> +    oneOf:
>> +      - const: rockchip,sfc
> Use 'enum' instead of oneOf+const.
>
> You need an SoC specific compatible.


The rockchip sfc controller is a standalone IP with version register, 
and the driver can

handle all the feature difference inside the IP, so we would like to use 
a more generic

compatible name instead of bind to any of SoC name. So can we use 
"rockchip,sfc"

like "snps,designware-spi", which is a generic one, instead of an SoC 
specific compatible?


Thanks,

- Kever