[PATCH v13 0/6] Add Rockchip SFC(serial flash controller) support
Peter Geis
pgwipeout at gmail.com
Mon Aug 16 17:52:07 PDT 2021
On Thu, Aug 12, 2021 at 9:49 AM Jon Lin <jon.lin at rock-chips.com> wrote:
>
Good Evening,
Tested successfully on the rk3566 based Quartz64 Model A.
Tested-by: Peter Geis <pgwipeout at gmail.com>
Very Respectfully,
Peter Geis
>
>
> Changes in v13:
> - Provide independent interfaces to obtain RX TX FIFO status respectively
> - Add more debug information
> - Depress DMA limitation
>
> Changes in v12:
> - Remove useless oneOf lable
> - Add sfc controller discription
> - Remove the limitation of SFC_MIN_SPEED_HZ
> - Add IRQ_NONE method for irq handler
> - Add SPI_MASTER_HALF_DUPLEX flags
> - Add sfc interrupt mask bits and status register initial progress
>
> Changes in v11:
> - The tx is set to 1 for Odroid Go Advance device
>
> Changes in v10:
> - Fix dma transfer logic
>
> Changes in v9:
> - Separate DMA IRQ setting and wait_completion from DMA fifo transfer
> function to make dma_status_poll be possible(Which I will implement
> in u-boot)
> - Add SFC Kconfig detail comment
>
> Changes in v8:
> - Fix indent 4 to 2 in yaml
>
> Changes in v7:
> - Fix up the sclk_sfc parent error in rk3036
> - Unify to "rockchip,sfc" compatible id because all the feature update
> will have a new IP version, so the driver is used for the SFC IP in
> all SoCs
> - Change to use node "sfc" to name the SFC pinctrl group
> - Add subnode reg property check
> - Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case
> - Limit max_iosize to 32KB
>
> Changes in v6:
> - Add support in device trees for rv1126(Declared in series 5 but not
> submitted)
> - Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not
> affect interpretation and has been widely used
> - Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted)
> - Simplify the code, such as remove "rockchip_sfc_register_all"(Declared
> in series 5 but not submitted)
> - Support SFC ver4 ver5(Declared in series 5 but not submitted)
> - Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c
> - Change to use devm_spi_alloc_master and spi_unregister_master
>
> Changes in v5:
> - Add support in device trees for rv1126
> - Support sfc tx_dual, tx_quad
> - Simplify the code, such as remove "rockchip_sfc_register_all"
> - Support SFC ver4 ver5
>
> Changes in v4:
> - Changing patch back to an "RFC". An engineer from Rockchip
> reached out to me to let me know they are working on this patch for
> upstream, I am submitting this v4 for the community to see however
> I expect Jon Lin (jon.lin at rock-chips.com) will submit new patches
> soon and these are the ones we should pursue for mainlining. Jon's
> patch series should include support for more hardware than this
> series.
> - Clean up documentation more and ensure it is correct per
> make dt_binding_check.
> - Add support in device trees for rk3036, rk3308, and rv1108.
> - Add ahb clock (hclk_sfc) support for rk3036.
> - Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
> - Change IRQ code to only mark IRQ as handled if it handles the
> specific IRQ (DMA transfer finish) it is supposed to handle.
>
> Changes in v3:
> - Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
> - Changed the compatible string from rockchip,sfc to
> rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
> driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
> RV1108 SoCs, and possibly more. However, I am currently only able
> to test this on a PX30 (an RK3326). The technical reference manuals
> appear to list the same registers for each device.
> - Corrected devicetree documentation for formatting and to note these
> changes.
> - Replaced the maintainer with Heiko Stuebner and myself, as we will
> take ownership of this going forward.
> - Noted that the device (per the reference manual) supports 4 CS, but
> I am only able to test a single CS (CS 0).
> - Reordered patches to comply with upstream rules.
>
> Changes in v2:
> - Reimplemented driver using spi-mem subsystem.
> - Removed power management code as I couldn't get it working properly.
> - Added device tree bindings for Odroid Go Advance.
>
> Changes in v1:
> hanges made in this new series versus the v8 of the old series:
> - Added function to read spi-rx-bus-width from device tree, in the
> event that the SPI chip supports 4x mode but only has 2 pins
> wired (such as the Odroid Go Advance).
> - Changed device tree documentation from txt to yaml format.
> - Made "reset" message a dev_dbg from a dev_info.
> - Changed read and write fifo functions to remove redundant checks.
> - Changed the write and read from relaxed to non-relaxed when
> starting the DMA transfer or reading the DMA IRQ.
> - Changed from dma_coerce_mask_and_coherent to just
> dma_set_mask_and_coherent.
> - Changed name of get_if_type to rockchip_sfc_get_if_type.
>
> Chris Morgan (6):
> dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash
> controller
> spi: rockchip-sfc: add rockchip serial flash controller
> arm64: dts: rockchip: Add SFC to PX30
> arm: dts: rockchip: Add SFC to RV1108
> arm64: dts: rockchip: Add SFC to RK3308
> arm64: dts: rockchip: Enable SFC for Odroid Go Advance
>
> .../devicetree/bindings/spi/rockchip-sfc.yaml | 91 +++
> arch/arm/boot/dts/rv1108.dtsi | 37 +
> arch/arm64/boot/dts/rockchip/px30.dtsi | 38 +
> arch/arm64/boot/dts/rockchip/rk3308.dtsi | 37 +
> .../boot/dts/rockchip/rk3326-odroid-go2.dts | 16 +
> drivers/spi/Kconfig | 12 +
> drivers/spi/Makefile | 1 +
> drivers/spi/spi-rockchip-sfc.c | 694 ++++++++++++++++++
> 8 files changed, 926 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
> create mode 100644 drivers/spi/spi-rockchip-sfc.c
>
> --
> 2.17.1
>
>
>
>
> _______________________________________________
> Linux-rockchip mailing list
> Linux-rockchip at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/linux-rockchip
More information about the Linux-rockchip
mailing list