[PATCH v2 79/79] media: hantro: document the usage of pm_runtime_get_sync()

[Mauro Carvalho Chehab]

Despite other *_get()/*_put() functions, where usage count is
incremented only if not errors, the pm_runtime_get_sync() has
a different behavior, incrementing the counter *even* on
errors.

That's an error prone behavior, as people often forget to
decrement the usage counter.

However, the hantro driver depends on this behavior, as it
will decrement the usage_count unconditionally at the m2m
job finish time, which makes sense.

So, intead of using the pm_runtime_resume_and_get() that
would decrement the counter on error, keep the current
API, but add a documentation explaining the rationale for
keep using pm_runtime_get_sync().

Signed-off-by: Mauro Carvalho Chehab <mchehab+huawei at kernel.org>
---
 drivers/staging/media/hantro/hantro_drv.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/staging/media/hantro/hantro_drv.c b/drivers/staging/media/hantro/hantro_drv.c
index 595e82a82728..96f940c1c85c 100644
--- a/drivers/staging/media/hantro/hantro_drv.c
+++ b/drivers/staging/media/hantro/hantro_drv.c
@@ -155,6 +155,13 @@ static void device_run(void *priv)
 	ret = clk_bulk_enable(ctx->dev->variant->num_clocks, ctx->dev->clocks);
 	if (ret)
 		goto err_cancel_job;
+
+	/*
+	 * The pm_runtime_get_sync() will increment dev->power.usage_count,
+	 * even on errors. That's the expected behavior here, since the
+	 * hantro_job_finish() function at the error handling code
+	 * will internally call pm_runtime_put_autosuspend().
+	 */
 	ret = pm_runtime_get_sync(ctx->dev->dev);
 	if (ret < 0)
 		goto err_cancel_job;
-- 
2.30.2