[PATCH v2 1/2] ARM: dts: rk3188: correct interrupt flags

Krzysztof Kozlowski krzk at kernel.org
Thu Sep 17 14:52:10 EDT 2020


GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
These are simple defines so they could be used in DTS but they will not
have the same meaning:
1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING

Correct the interrupt flags without affecting the code:
  ACTIVE_HIGH => IRQ_TYPE_NONE

Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>

---

Not tested on HW.

Changes since v1:
1. Correct title
---
 arch/arm/boot/dts/rk3188-bqedison2qc.dts | 3 ++-
 1 file changed, 2 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/rk3188-bqedison2qc.dts b/arch/arm/boot/dts/rk3188-bqedison2qc.dts
index 66a0ff196eb1..b191347894f6 100644
--- a/arch/arm/boot/dts/rk3188-bqedison2qc.dts
+++ b/arch/arm/boot/dts/rk3188-bqedison2qc.dts
@@ -7,6 +7,7 @@
 /dts-v1/;
 #include <dt-bindings/i2c/i2c.h>
 #include <dt-bindings/input/input.h>
+#include <dt-bindings/interrupt-controller/irq.h>
 #include "rk3188.dtsi"
 
 / {
@@ -479,7 +480,7 @@
 		reg = <1>;
 		compatible = "brcm,bcm4329-fmac";
 		interrupt-parent = <&gpio3>;
-		interrupts = <RK_PD2 GPIO_ACTIVE_HIGH>;
+		interrupts = <RK_PD2 IRQ_TYPE_NONE>;
 		interrupt-names = "host-wake";
 		brcm,drive-strength = <5>;
 		pinctrl-names = "default";
-- 
2.17.1




More information about the Linux-rockchip mailing list