[PATCH v2 1/2] ARM: dts: rk3188: correct interrupt flags

[Heiko Stübner]

Hi,

Am Freitag, 2. Oktober 2020, 18:11:28 CEST schrieb Krzysztof Kozlowski:
> On Thu, Sep 17, 2020 at 08:52:10PM +0200, Krzysztof Kozlowski wrote:
> > GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
> > These are simple defines so they could be used in DTS but they will not
> > have the same meaning:
> > 1. GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE
> > 2. GPIO_ACTIVE_LOW  = 1 = IRQ_TYPE_EDGE_RISING
> > 
> > Correct the interrupt flags without affecting the code:
> >   ACTIVE_HIGH => IRQ_TYPE_NONE
> > 
> > Signed-off-by: Krzysztof Kozlowski <krzk at kernel.org>
> > 
> > ---
> > 
> > Not tested on HW.
> > 
> > Changes since v1:
> > 1. Correct title
> > ---
> >  arch/arm/boot/dts/rk3188-bqedison2qc.dts | 3 ++-
> >  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> Hi,
> 
> Any comments/review/testing from Heiko or other Rockchip folks? Shall I
> cc here someone?

I'm actually wondering about this ... I somehow remember writing a response,
but don't see it in my history - so it might have gotten lost before I
actually sent it.

I think the biggest issue I have is that none of that is tested on any
hardware and looking at other brcm wifi drivers in the kernel, the
interrupt polarity seems to be all over the place, some set it high,
some low and I even have seen edge triggers.

As all changes are in regard to (copied) brcm wifi node, it would be
really interesting to actually know what trigger is the right one.

I've Cc'ed Jagan who I think has worked on an affected board,
maybe he can check which trigger is correct.


Heiko