[PATCH v2 08/12] media: rkvdec: h264: Use bytesperline and buffer height to calculate stride

[Jonas Karlman]

Use bytesperline and buffer height to calculate the strides configured.

This does not really change anything other than ensuring the bytesperline
that is signaled to userspace matches what is configured in HW.

Signed-off-by: Jonas Karlman <jonas at kwiboo.se>
---
Changes in v2:
- Drop code refactoring
---
 drivers/staging/media/rkvdec/rkvdec-h264.c | 10 +++++-----
 1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/staging/media/rkvdec/rkvdec-h264.c b/drivers/staging/media/rkvdec/rkvdec-h264.c
index 3a85545bcb38..10756b9d6118 100644
--- a/drivers/staging/media/rkvdec/rkvdec-h264.c
+++ b/drivers/staging/media/rkvdec/rkvdec-h264.c
@@ -891,9 +891,9 @@ static void config_registers(struct rkvdec_ctx *ctx,
 	dma_addr_t rlc_addr;
 	dma_addr_t refer_addr;
 	u32 rlc_len;
-	u32 hor_virstride = 0;
-	u32 ver_virstride = 0;
-	u32 y_virstride = 0;
+	u32 hor_virstride;
+	u32 ver_virstride;
+	u32 y_virstride;
 	u32 yuv_virstride = 0;
 	u32 offset;
 	dma_addr_t dst_addr;
@@ -904,8 +904,8 @@ static void config_registers(struct rkvdec_ctx *ctx,
 
 	f = &ctx->decoded_fmt;
 	dst_fmt = &f->fmt.pix_mp;
-	hor_virstride = (sps->bit_depth_luma_minus8 + 8) * dst_fmt->width / 8;
-	ver_virstride = round_up(dst_fmt->height, 16);
+	hor_virstride = dst_fmt->plane_fmt[0].bytesperline;
+	ver_virstride = dst_fmt->height;
 	y_virstride = hor_virstride * ver_virstride;
 
 	if (sps->chroma_format_idc == 0)
-- 
2.17.1