[PATCH v1 3/5] arm64: dts: rockchip: Add gpio-syscon10 to rk3328

[Robin Murphy]

On 10/05/18 10:16, djw at t-chip.com.cn wrote:
> From: Levin Du <djw at t-chip.com.cn>
> 
> Adding a new gpio controller named "gpio-syscon10" to rk3328, providing
> access to the pins defined in the syscon GRF_SOC_CON10.

This is the GPIO_MUTE pin, right? The public TRM is rather vague, but 
cross-referencing against the datasheet and schematics implies that it's 
the "gpiomut_*" part of the GRF bit names which is most significant.

It might be worth using a more descriptive name here, since "syscon10" 
is pretty much meaningless at the board level.

Robin.

> Boards using these special pins to control regulators or LEDs, can now
> utilize existing drivers like gpio-regulator and leds-gpio.
> 
> Signed-off-by: Levin Du <djw at t-chip.com.cn>
> 
> ---
> 
> Changes in v1:
> - Split from V0 and add to rk3328.dtsi for general use.
> 
>   arch/arm64/boot/dts/rockchip/rk3328.dtsi | 6 ++++++
>   1 file changed, 6 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3328.dtsi b/arch/arm64/boot/dts/rockchip/rk3328.dtsi
> index b8e9da1..73a822d 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3328.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3328.dtsi
> @@ -309,6 +309,12 @@
>   			mode-loader = <BOOT_BL_DOWNLOAD>;
>   		};
>   
> +		gpio_syscon10: gpio-syscon10 {
> +			compatible = "rockchip,gpio-syscon";
> +			gpio-controller;
> +			#gpio-cells = <2>;
> +			gpio,syscon-dev = <0 0x0428 0>;
> +		};
>   	};
>   
>   	uart0: serial at ff110000 {
>