[PATCH v3 3/6] phy: rockchip-typec: enable usb3 host during usb3 phy power on

[Heiko Stuebner]

Am Freitag, 16. Februar 2018, 13:09:53 CET schrieb Enric Balletbo i Serra:
> From: William wu <wulf at rock-chips.com>
> 
> We have forced usb3 to work in usb2 only mode in firmware by setting
> usb3tousb2_en (bit3 of GRF_USB3PHY0/1_CON0) to 1, and setting
> host_u3_port_disable (bit0 of GRF_USB3OTG0/1_CON1) to 1 and host_u3_port
> (bit15~12 of GRF_USB3OTG0/1_CON1) to 0. So we need to re-enable usb3
> host.
> 
> Note that the RK3399 TRM suggests that we should keep the whole usb3
> controller in reset for the duration of the Type-C PHY initialization.
> However, it's hard to assert the reset in the current framework of
> reset. And according to the TRM, it doesn't require that we should
> clear the usb3tousb2 bit before pipe ready. So let's enable the usb3
> host after pipe ready to avoid the Type-C PHY initialization failure.
> 
> Signed-off-by: William wu <wulf at rock-chips.com>
> Signed-off-by: Enric Balletbo i Serra <enric.balletbo at collabora.com>

Reviewed-by: Heiko Stuebner <heiko at sntech.de>