[PATCH] PCI: rockchip: improve the training polling code
Shawn Lin
shawn.lin at rock-chips.com
Wed Jan 18 00:29:15 PST 2017
Use the readl_poll_timeout instead of open coding them.
Signed-off-by: Shawn Lin <shawn.lin at rock-chips.com>
---
drivers/pci/host/pcie-rockchip.c | 52 +++++++++++++---------------------------
1 file changed, 16 insertions(+), 36 deletions(-)
diff --git a/drivers/pci/host/pcie-rockchip.c b/drivers/pci/host/pcie-rockchip.c
index 0d6e8ee..17374a9 100644
--- a/drivers/pci/host/pcie-rockchip.c
+++ b/drivers/pci/host/pcie-rockchip.c
@@ -188,8 +188,11 @@
(PCIE_ECAM_BUS(bus) | PCIE_ECAM_DEV(dev) | \
PCIE_ECAM_FUNC(func) | PCIE_ECAM_REG(reg))
#define PCIE_LINK_IS_L2(x) \
- (((x) & PCIE_CLIENT_DEBUG_LTSSM_MASK) == \
- PCIE_CLIENT_DEBUG_LTSSM_L2)
+ (((x) & PCIE_CLIENT_DEBUG_LTSSM_MASK) == PCIE_CLIENT_DEBUG_LTSSM_L2)
+#define PCIE_LINK_UP(x) \
+ (((x) & PCIE_CLIENT_LINK_STATUS_MASK) == PCIE_CLIENT_LINK_STATUS_UP)
+#define PCIE_LINK_IS_GEN2(x) \
+ (((x) & PCIE_CORE_PL_CONF_SPEED_MASK) == PCIE_CORE_PL_CONF_SPEED_5G)
#define RC_REGION_0_ADDR_TRANS_H 0x00000000
#define RC_REGION_0_ADDR_TRANS_L 0x00000000
@@ -463,7 +466,6 @@ static int rockchip_pcie_init_port(struct rockchip_pcie *rockchip)
struct device *dev = rockchip->dev;
int err;
u32 status;
- unsigned long timeout;
gpiod_set_value(rockchip->ep_gpio, 0);
@@ -604,23 +606,12 @@ static int rockchip_pcie_init_port(struct rockchip_pcie *rockchip)
gpiod_set_value(rockchip->ep_gpio, 1);
/* 500ms timeout value should be enough for Gen1/2 training */
- timeout = jiffies + msecs_to_jiffies(500);
-
- for (;;) {
- status = rockchip_pcie_read(rockchip,
- PCIE_CLIENT_BASIC_STATUS1);
- if ((status & PCIE_CLIENT_LINK_STATUS_MASK) ==
- PCIE_CLIENT_LINK_STATUS_UP) {
- dev_dbg(dev, "PCIe link training gen1 pass!\n");
- break;
- }
-
- if (time_after(jiffies, timeout)) {
- dev_err(dev, "PCIe link training gen1 timeout!\n");
- return -ETIMEDOUT;
- }
-
- msleep(20);
+ err = readl_poll_timeout(rockchip->apb_base + PCIE_CLIENT_BASIC_STATUS1,
+ status, PCIE_LINK_UP(status), 20,
+ 500 * USEC_PER_MSEC);
+ if (err) {
+ dev_err(dev, "PCIe link training gen1 timeout!\n");
+ return -ETIMEDOUT;
}
if (rockchip->link_gen == 2) {
@@ -632,22 +623,11 @@ static int rockchip_pcie_init_port(struct rockchip_pcie *rockchip)
status |= PCI_EXP_LNKCTL_RL;
rockchip_pcie_write(rockchip, status, PCIE_RC_CONFIG_LCS);
- timeout = jiffies + msecs_to_jiffies(500);
- for (;;) {
- status = rockchip_pcie_read(rockchip, PCIE_CORE_CTRL);
- if ((status & PCIE_CORE_PL_CONF_SPEED_MASK) ==
- PCIE_CORE_PL_CONF_SPEED_5G) {
- dev_dbg(dev, "PCIe link training gen2 pass!\n");
- break;
- }
-
- if (time_after(jiffies, timeout)) {
- dev_dbg(dev, "PCIe link training gen2 timeout, fall back to gen1!\n");
- break;
- }
-
- msleep(20);
- }
+ err = readl_poll_timeout(rockchip->apb_base + PCIE_CORE_CTRL,
+ status, PCIE_LINK_IS_GEN2(status), 20,
+ 500 * USEC_PER_MSEC);
+ if (err)
+ dev_dbg(dev, "PCIe link training gen2 timeout, fall back to gen1!\n");
}
/* Check the final link width from negotiated lane counter from MGMT */
--
1.9.1
More information about the Linux-rockchip
mailing list