[PATCH 10/26] drm/rockchip: dw-mipi-dsi: only request HS clock when required

[John Keeping]

Requesting the HS clock from the PHY before we initialize it causes an
invalid signal to be sent out since the input clock is not yet
configured.  The PHY databook suggests only asserting this signal when
performing HS transfers, so let's do that.

Signed-off-by: John Keeping <john at metanate.com>
---
 drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
index 554336f8023e..ed2da1bbada9 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
@@ -546,13 +546,15 @@ static int dw_mipi_dsi_host_detach(struct mipi_dsi_host *host,
 static void dw_mipi_message_config(struct dw_mipi_dsi *dsi,
 				   const struct mipi_dsi_msg *msg)
 {
+	bool lpm = msg->flags & MIPI_DSI_MSG_USE_LPM;
 	u32 val = 0;
 
 	if (msg->flags & MIPI_DSI_MSG_REQ_ACK)
 		val |= EN_ACK_RQST;
-	if (msg->flags & MIPI_DSI_MSG_USE_LPM)
+	if (lpm)
 		val |= CMD_MODE_ALL_LP;
 
+	dsi_write(dsi, DSI_LPCLK_CTRL, lpm ? 0 : PHY_TXREQUESTCLKHS);
 	dsi_write(dsi, DSI_CMD_MODE_CFG, val);
 }
 
@@ -694,6 +696,7 @@ static void dw_mipi_dsi_set_mode(struct dw_mipi_dsi *dsi,
 		dsi_write(dsi, DSI_PWR_UP, RESET);
 		dsi_write(dsi, DSI_MODE_CFG, ENABLE_VIDEO_MODE);
 		dw_mipi_dsi_video_mode_config(dsi);
+		dsi_write(dsi, DSI_LPCLK_CTRL, PHY_TXREQUESTCLKHS);
 		dsi_write(dsi, DSI_PWR_UP, POWERUP);
 	}
 }
@@ -711,7 +714,6 @@ static void dw_mipi_dsi_init(struct dw_mipi_dsi *dsi)
 		  | PHY_RSTZ | PHY_SHUTDOWNZ);
 	dsi_write(dsi, DSI_CLKMGR_CFG, TO_CLK_DIVIDSION(10) |
 		  TX_ESC_CLK_DIVIDSION(7));
-	dsi_write(dsi, DSI_LPCLK_CTRL, PHY_TXREQUESTCLKHS);
 }
 
 static void dw_mipi_dsi_dpi_config(struct dw_mipi_dsi *dsi)
-- 
2.10.0.278.g4f427b1.dirty