[PATCH v2 5/5] thermal: rockchip: handle set_trips without the trip points

[Caesar Wang]

In some cases, some sensors didn't need the trip points, the
set_trips will return {-INT_MAX, INT_MAX} to trigger thermal alarm.

Signed-off-by: Caesar Wang <wxt at rock-chips.com>
---

Changes in v2:
- Fixes something as Brian comments on
  https://patchwork.kernel.org/patch/9440989.

Changes in v1: None

 drivers/thermal/rockchip_thermal.c | 16 +++++++++++++++-
 1 file changed, 15 insertions(+), 1 deletion(-)

diff --git a/drivers/thermal/rockchip_thermal.c b/drivers/thermal/rockchip_thermal.c
index 0d50df7..f873053 100644
--- a/drivers/thermal/rockchip_thermal.c
+++ b/drivers/thermal/rockchip_thermal.c
@@ -675,7 +675,21 @@ static int rk_tsadcv2_get_temp(const struct chip_tsadc_table *table,
 static int rk_tsadcv2_alarm_temp(const struct chip_tsadc_table *table,
 				  int chn, void __iomem *regs, int temp)
 {
-	u32 alarm_value, int_en;
+	u32 alarm_value;
+	u32 int_en, int_clr;
+
+	/*
+	 * In some cases, some sensors didn't need the trip points, the
+	 * set_trips will pass {-INT_MAX, INT_MAX} to trigger tsadc alarm
+	 * in the end, ignore this case and disable the high temperature
+	 * interrupt.
+	 */
+	if (temp == INT_MAX) {
+		int_clr = readl_relaxed(regs + TSADCV2_INT_EN);
+		int_clr &= ~TSADCV2_INT_SRC_EN(chn);
+		writel_relaxed(int_clr, regs + TSADCV2_INT_EN);
+		return 0;
+	}
 
 	/* Make sure the value is valid */
 	alarm_value = rk_tsadcv2_temp_to_code(table, temp);
-- 
2.7.4