[PATCH v2 02/11] mmc: sdhci-of-arasan: Always power the PHY off/on when clock changes

[Shawn Lin]

在 2016/6/14 7:04, Douglas Anderson 写道:
> In commit 802ac39a5566 ("mmc: sdhci-of-arasan: fix set_clock when a phy
> is supported") we added code to power the PHY off and on whenever the
> clock was changed but we avoided doing the power cycle code when the
> clock was low speed.  Let's now do it always.
>
> Although there may be other reasons for power cycling the PHY when the
> clock changes, one of the main reasons is that we need to give the DLL a
> chance to re-lock with the new clock.
>
> One of the things that the DLL is for is tuning the Receive Clock in
> HS200 mode and STRB in HS400 mode.  Thus it is clear that we should make
> sure we power cycle the PHY (and wait for the DLL to lock) when we know
> we'll be in one of these two speed modes.  That's what the original code
> did, though it used the clock rate rather than the speed mode.  However,
> even in speed modes other than HS200,/HS400 the DLL is used for
> something since it can be clearly observed that the PHY doesn't function
> properly if you leave the DLL off.
>
> Although it appears less important to power cycle the PHY and wait for
> the DLL to lock when not in HS200/HS400 modes (no bugs were reported),
> it still seems wise to let the locking always happen nevertheless.
>
> Note: as part of this, we make sure that we never try to turn the PHY on
> when the clock is off (when the clock rate is 0).  The PHY cannot work
> when the clock is off since its DLL can't lock.
>
> This change requires ("phy: rockchip-emmc: Increase lock time
> allowance") and will cause problems if picked without that change.

Thanks for doint it.

Reviewed-by: Shawn Lin <shawn.lin at rock-chips.com>

>
> Signed-off-by: Douglas Anderson <dianders at chromium.org>
> ---
> Changes in v2: None
>
>  drivers/mmc/host/sdhci-of-arasan.c | 23 ++++++++---------------
>  1 file changed, 8 insertions(+), 15 deletions(-)
>
> diff --git a/drivers/mmc/host/sdhci-of-arasan.c b/drivers/mmc/host/sdhci-of-arasan.c
> index 533e2bcb10bc..3ff1711077c2 100644
> --- a/drivers/mmc/host/sdhci-of-arasan.c
> +++ b/drivers/mmc/host/sdhci-of-arasan.c
> @@ -35,11 +35,13 @@
>  /**
>   * struct sdhci_arasan_data
>   * @clk_ahb:	Pointer to the AHB clock
> - * @phy: Pointer to the generic phy
> + * @phy:	Pointer to the generic phy
> + * @phy_on:	True if the PHY is turned on.
>   */
>  struct sdhci_arasan_data {
>  	struct clk	*clk_ahb;
>  	struct phy	*phy;
> +	bool		phy_on;
>  };
>
>  static unsigned int sdhci_arasan_get_timeout_clock(struct sdhci_host *host)
> @@ -61,12 +63,10 @@ static void sdhci_arasan_set_clock(struct sdhci_host *host, unsigned int clock)
>  {
>  	struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
>  	struct sdhci_arasan_data *sdhci_arasan = sdhci_pltfm_priv(pltfm_host);
> -	bool ctrl_phy = false;
>
> -	if (clock > MMC_HIGH_52_MAX_DTR && (!IS_ERR(sdhci_arasan->phy)))
> -		ctrl_phy = true;
> +	if (sdhci_arasan->phy_on && !IS_ERR(sdhci_arasan->phy)) {
> +		sdhci_arasan->phy_on = false;
>
> -	if (ctrl_phy) {
>  		spin_unlock_irq(&host->lock);
>  		phy_power_off(sdhci_arasan->phy);
>  		spin_lock_irq(&host->lock);
> @@ -74,7 +74,9 @@ static void sdhci_arasan_set_clock(struct sdhci_host *host, unsigned int clock)
>
>  	sdhci_set_clock(host, clock);
>
> -	if (ctrl_phy) {
> +	if (host->mmc->actual_clock && !IS_ERR(sdhci_arasan->phy)) {
> +		sdhci_arasan->phy_on = true;
> +
>  		spin_unlock_irq(&host->lock);
>  		phy_power_on(sdhci_arasan->phy);
>  		spin_lock_irq(&host->lock);
> @@ -257,12 +259,6 @@ static int sdhci_arasan_probe(struct platform_device *pdev)
>  			goto clk_disable_all;
>  		}
>
> -		ret = phy_power_on(sdhci_arasan->phy);
> -		if (ret < 0) {
> -			dev_err(&pdev->dev, "phy_power_on err.\n");
> -			goto err_phy_power;
> -		}
> -
>  		host->mmc_host_ops.hs400_enhanced_strobe =
>  					sdhci_arasan_hs400_enhanced_strobe;
>  	}
> @@ -275,9 +271,6 @@ static int sdhci_arasan_probe(struct platform_device *pdev)
>
>  err_add_host:
>  	if (!IS_ERR(sdhci_arasan->phy))
> -		phy_power_off(sdhci_arasan->phy);
> -err_phy_power:
> -	if (!IS_ERR(sdhci_arasan->phy))
>  		phy_exit(sdhci_arasan->phy);
>  clk_disable_all:
>  	clk_disable_unprepare(clk_xin);
>


-- 
Best Regards
Shawn Lin