[PATCH v4 1/2] mfd: dt-bindings: add the description about dvs gpio for rk808

[Chris Zhong]

add the description about dvs1, dvs2, and add the example.

Signed-off-by: Chris Zhong <zyw at rock-chips.com>
Reviewed-by: Doug Anderson <dianders at chromium.org>

---

Changes in v4:
- Remove the description about dvs-ok

Changes in v3:
- Modify the syntax error

Changes in v2:
- increase description about dvs pins

 Documentation/devicetree/bindings/mfd/rk808.txt | 8 +++++++-
 1 file changed, 7 insertions(+), 1 deletion(-)

diff --git a/Documentation/devicetree/bindings/mfd/rk808.txt b/Documentation/devicetree/bindings/mfd/rk808.txt
index 9e6e259..4ca6aab 100644
--- a/Documentation/devicetree/bindings/mfd/rk808.txt
+++ b/Documentation/devicetree/bindings/mfd/rk808.txt
@@ -24,6 +24,10 @@ Optional properties:
 - vcc10-supply: The input supply for LDO_REG6
 - vcc11-supply: The input supply for LDO_REG8
 - vcc12-supply: The input supply for SWITCH_REG2
+- dvs-gpios:  buck1/2 can be controlled by gpio dvs, this is GPIO specifiers
+  for 2 host gpio's used for dvs. The format of the gpio specifier depends in
+  the gpio controller. If DVS GPIOs aren't present, voltage changes will happen
+  very quickly with no slow ramp time.
 
 Regulators: All the regulators of RK808 to be instantiated shall be
 listed in a child node named 'regulators'. Each regulator is represented
@@ -55,7 +59,9 @@ Example:
 		interrupt-parent = <&gpio0>;
 		interrupts = <4 IRQ_TYPE_LEVEL_LOW>;
 		pinctrl-names = "default";
-		pinctrl-0 = <&pmic_int>;
+		pinctrl-0 = <&pmic_int &dvs_1 &dvs_2>;
+		dvs-gpios = <&gpio7 11 GPIO_ACTIVE_HIGH>,
+			    <&gpio7 15 GPIO_ACTIVE_HIGH>;
 		reg = <0x1b>;
 		rockchip,system-power-controller;
 		wakeup-source;
-- 
1.9.1