[PATCH v7 2/5] phy: add a driver for the Rockchip SoC internal USB2.0 PHY
Yunzhi Li
lyz at rock-chips.com
Wed Jan 21 02:21:10 PST 2015
Hi Kishon :
> Hi,
>
> On Wednesday 21 January 2015 03:36 PM, Yunzhi Li wrote:
>> Hi Kishon :
>>> Hi,
>>>
>>> On Friday 12 December 2014 08:37 PM, Yunzhi Li wrote:
>>>> This patch to add a generic PHY driver for ROCKCHIP usb PHYs,
>>>> currently this driver can support RK3288. The RK3288 SoC have
>>>> three independent USB PHY IPs which are all configured through a
>>>> set of registers located in the GRF (general register files)
>>>> module.
>>>>
>>>> Signed-off-by: Yunzhi Li <lyz at rock-chips.com>
>>>>
>>>> ---
>>>>
>>>> Changes in v7:
>>>> - Accept Kishon's comments to use phandle args to find a phy
>>>> struct directly and get rid of using a custom of_xlate
>>>> function.
>>>>
>>>> Changes in v6:
>>>> - Rename SIDDQ_MSK to SIDDQ_WRITE_ENA.
>>>>
>>>> Changes in v5: None
>>>> Changes in v4:
>>>> - Get number of PHYs from device tree.
>>>> - Model each PHY as subnode of the phy provider node.
>>>>
>>>> Changes in v3:
>>>> - Use BIT macro instead of bit shift ops.
>>>> - Rename the config entry to PHY_ROCKCHIP_USB.
>>>>
>>>> drivers/phy/Kconfig | 7 ++
>>>> drivers/phy/Makefile | 1 +
>>>> drivers/phy/phy-rockchip-usb.c | 158
>>>> +++++++++++++++++++++++++++++++++++++++++
>>>> 3 files changed, 166 insertions(+)
>>>> create mode 100644 drivers/phy/phy-rockchip-usb.c
>>>>
>>>> diff --git a/drivers/phy/Kconfig b/drivers/phy/Kconfig
>>>> index ccad880..b24500a 100644
>>>> --- a/drivers/phy/Kconfig
>>>> +++ b/drivers/phy/Kconfig
>>>> @@ -239,6 +239,13 @@ config PHY_QCOM_IPQ806X_SATA
>>>> depends on OF
>>>> select GENERIC_PHY
>>>> +config PHY_ROCKCHIP_USB
>>>> + tristate "Rockchip USB2 PHY Driver"
>>>> + depends on ARCH_ROCKCHIP && OF
>>>> + select GENERIC_PHY
>>>> + help
>>>> + Enable this to support the Rockchip USB 2.0 PHY.
>>>> +
>>>> config PHY_ST_SPEAR1310_MIPHY
>>>> tristate "ST SPEAR1310-MIPHY driver"
>>>> select GENERIC_PHY
>>>> diff --git a/drivers/phy/Makefile b/drivers/phy/Makefile
>>>> index aa74f96..48bf5a1 100644
>>>> --- a/drivers/phy/Makefile
>>>> +++ b/drivers/phy/Makefile
>>>> @@ -28,6 +28,7 @@ phy-exynos-usb2-$(CONFIG_PHY_EXYNOS5250_USB2) +=
>>>> phy-exynos5250-usb2.o
>>>> phy-exynos-usb2-$(CONFIG_PHY_S5PV210_USB2) += phy-s5pv210-usb2.o
>>>> obj-$(CONFIG_PHY_EXYNOS5_USBDRD) += phy-exynos5-usbdrd.o
>>>> obj-$(CONFIG_PHY_QCOM_APQ8064_SATA) += phy-qcom-apq8064-sata.o
>>>> +obj-$(CONFIG_PHY_ROCKCHIP_USB) += phy-rockchip-usb.o
>>>> obj-$(CONFIG_PHY_QCOM_IPQ806X_SATA) += phy-qcom-ipq806x-sata.o
>>>> obj-$(CONFIG_PHY_ST_SPEAR1310_MIPHY) += phy-spear1310-miphy.o
>>>> obj-$(CONFIG_PHY_ST_SPEAR1340_MIPHY) += phy-spear1340-miphy.o
>>>> diff --git a/drivers/phy/phy-rockchip-usb.c b/drivers/phy/phy-rockchip-usb.c
>>>> new file mode 100644
>>>> index 0000000..22011c3
>>>> --- /dev/null
>>>> +++ b/drivers/phy/phy-rockchip-usb.c
>>>> @@ -0,0 +1,158 @@
>>>> +/*
>>>> + * Rockchip usb PHY driver
>>>> + *
>>>> + * Copyright (C) 2014 Yunzhi Li <lyz at rock-chips.com>
>>>> + * Copyright (C) 2014 ROCKCHIP, Inc.
>>>> + *
>>>> + * This program is free software; you can redistribute it and/or modify
>>>> + * it under the terms of the GNU General Public License as published by
>>>> + * the Free Software Foundation; either version 2 of the License.
>>>> + *
>>>> + * This program is distributed in the hope that it will be useful,
>>>> + * but WITHOUT ANY WARRANTY; without even the implied warranty of
>>>> + * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
>>>> + * GNU General Public License for more details.
>>>> + */
>>>> +
>>>> +#include <linux/clk.h>
>>>> +#include <linux/io.h>
>>>> +#include <linux/kernel.h>
>>>> +#include <linux/module.h>
>>>> +#include <linux/mutex.h>
>>>> +#include <linux/of.h>
>>>> +#include <linux/of_address.h>
>>>> +#include <linux/phy/phy.h>
>>>> +#include <linux/platform_device.h>
>>>> +#include <linux/regulator/consumer.h>
>>>> +#include <linux/reset.h>
>>>> +#include <linux/regmap.h>
>>>> +#include <linux/mfd/syscon.h>
>>>> +
>>>> +/*
>>>> + * The higher 16-bit of this register is used for write protection
>>>> + * only if BIT(13 + 16) set to 1 the BIT(13) can be written.
>>>> + */
>>>> +#define SIDDQ_WRITE_ENA BIT(29)
>>>> +#define SIDDQ_ON BIT(13)
>>>> +#define SIDDQ_OFF (0 << 13)
>>>> +
>>>> +struct rockchip_usb_phy {
>>>> + unsigned int reg_offset;
>>>> + struct regmap *reg_base;
>>>> + struct clk *clk;
>>>> + struct phy *phy;
>>>> +};
>>>> +
>>>> +static int rockchip_usb_phy_power(struct rockchip_usb_phy *phy,
>>>> + bool siddq)
>>>> +{
>>>> + return regmap_write(phy->reg_base, phy->reg_offset,
>>>> + SIDDQ_WRITE_ENA | (siddq ? SIDDQ_ON : SIDDQ_OFF));
>>>> +}
>>>> +
>>>> +static int rockchip_usb_phy_power_off(struct phy *_phy)
>>>> +{
>>>> + struct rockchip_usb_phy *phy = phy_get_drvdata(_phy);
>>>> + int ret = 0;
>>>> +
>>>> + /* Power down usb phy analog blocks by set siddq 1 */
>>>> + ret = rockchip_usb_phy_power(phy, 1);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + clk_disable_unprepare(phy->clk);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + return 0;
>>>> +}
>>>> +
>>>> +static int rockchip_usb_phy_power_on(struct phy *_phy)
>>>> +{
>>>> + struct rockchip_usb_phy *phy = phy_get_drvdata(_phy);
>>>> + int ret = 0;
>>>> +
>>>> + ret = clk_prepare_enable(phy->clk);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + /* Power up usb phy analog blocks by set siddq 0 */
>>>> + ret = rockchip_usb_phy_power(phy, 0);
>>>> + if (ret)
>>>> + return ret;
>>>> +
>>>> + return 0;
>>>> +}
>>>> +
>>>> +static struct phy_ops ops = {
>>>> + .power_on = rockchip_usb_phy_power_on,
>>>> + .power_off = rockchip_usb_phy_power_off,
>>>> + .owner = THIS_MODULE,
>>>> +};
>>>> +
>>>> +static int rockchip_usb_phy_probe(struct platform_device *pdev)
>>>> +{
>>>> + struct device *dev = &pdev->dev;
>>>> + struct rockchip_usb_phy *rk_phy;
>>>> + struct phy_provider *phy_provider;
>>>> + struct device_node *child;
>>>> + struct regmap *grf;
>>>> + unsigned int reg_offset;
>>>> +
>>>> + grf = syscon_regmap_lookup_by_phandle(dev->of_node, "rockchip,grf");
>>>> + if (IS_ERR(grf)) {
>>>> + dev_err(&pdev->dev, "Missing rockchip,grf property\n");
>>>> + return PTR_ERR(grf);
>>>> + }
>>>> +
>>>> + for_each_available_child_of_node(dev->of_node, child) {
>>>> + rk_phy = devm_kzalloc(dev, sizeof(*rk_phy), GFP_KERNEL);
>>>> + if (!rk_phy)
>>>> + return -ENOMEM;
>>>> +
>>>> + if (of_property_read_u32(child, "reg", ®_offset)) {
>>>> + dev_err(dev, "missing reg property in node %s\n",
>>>> + child->name);
>>>> + return -EINVAL;
>>>> + }
>>>> +
>>>> + rk_phy->reg_offset = reg_offset;
>>>> + rk_phy->reg_base = grf;
>>>> +
>>>> + rk_phy->clk = of_clk_get_by_name(child, "phyclk");
>>>> + if (IS_ERR(rk_phy->clk))
>>>> + rk_phy->clk = NULL;
>>>> +
>>>> + rk_phy->phy = devm_phy_create(dev, child, &ops);
>>>> + if (IS_ERR(rk_phy->phy)) {
>>>> + dev_err(dev, "failed to create PHY\n");
>>>> + return PTR_ERR(rk_phy->phy);
>>>> + }
>>>> + phy_set_drvdata(rk_phy->phy, rk_phy);
>>>> + }
>>>> +
>>>> + phy_provider = devm_of_phy_provider_register(dev, of_phy_simple_xlate);
>>>> + return PTR_ERR_OR_ZERO(phy_provider);
>>>> +}
>>>> +
>>>> +static const struct of_device_id rockchip_usb_phy_dt_ids[] = {
>>>> + { .compatible = "rockchip,rk3288-usb-phy" },
>>> have you added devicetree binding documentation where I can find this
>>> compatible string?
>>>
>>> Thanks
>>> Kishon
>>>
>>>
>> You could find this documentation in this page :
>> https://lkml.org/lkml/2014/12/12/439
> Okay. I don't seem to have that patch in my mailbox. Is it already queued in
> some ones tree?
>
> Thanks
> Kishon
>
I will resend this mail to you
and until now I still don't know anybody have take this commit in his tree.
More information about the Linux-rockchip
mailing list