[PATCH v4 16/16] drm: bridge: analogix/dp: add edid modes parse in get_modes method

Yakir Yang ykk at rock-chips.com
Mon Aug 31 23:20:18 PDT 2015


Display Port monitor could support kinds of mode which indicate
in monitor edid, not just one single display resolution which
defined in panel or devivetree property display timing.

Signed-off-by: Yakir Yang <ykk at rock-chips.com>
---
Changes in v4:
- Call drm_panel_prepare() in .get_modes function, ensure panel should
  power on before driver try to read edid message.

Changes in v3:
- Add edid modes parse support

Changes in v2: None

 drivers/gpu/drm/bridge/analogix/analogix_dp_core.c | 31 ++++++++-------
 drivers/gpu/drm/bridge/analogix/analogix_dp_core.h | 46 +++++++++++-----------
 2 files changed, 40 insertions(+), 37 deletions(-)

diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
index 499ec57..c71e5f6 100644
--- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
+++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.c
@@ -111,7 +111,7 @@ static unsigned char analogix_dp_calc_edid_check_sum(unsigned char *edid_data)
 
 static int analogix_dp_read_edid(struct analogix_dp_device *dp)
 {
-	unsigned char edid[EDID_BLOCK_LENGTH * 2];
+	unsigned char *edid = dp->edid;
 	unsigned int extend_block = 0;
 	unsigned char sum;
 	unsigned char test_vector;
@@ -908,12 +908,6 @@ static void analogix_dp_commit(struct analogix_dp_device *dp)
 			DRM_ERROR("failed to disable the panel\n");
 	}
 
-	ret = analogix_dp_handle_edid(dp);
-	if (ret) {
-		dev_err(dp->dev, "unable to handle edid\n");
-		return;
-	}
-
 	ret = analogix_dp_set_link_train(dp, dp->video_info.max_lane_count,
 					 dp->video_info.max_link_rate);
 	if (ret) {
@@ -972,8 +966,24 @@ static int analogix_dp_get_modes(struct drm_connector *connector)
 {
 	struct analogix_dp_device *dp = connector_to_dp(connector);
 	struct analogix_dp_plat_data *plat_data = dp->plat_data;
+	struct edid *edid = (struct edid *)dp->edid;
 	int num_modes = 0;
 
+	if (dp->plat_data && dp->plat_data->panel) {
+		if (drm_panel_prepare(dp->plat_data->panel)) {
+			DRM_ERROR("failed to setup the panel\n");
+			return -EINVAL;
+		}
+	}
+
+	if (analogix_dp_handle_edid(dp)) {
+		dev_err(dp->dev, "unable to handle edid\n");
+		return -EINVAL;
+	}
+
+	drm_mode_connector_update_edid_property(connector, edid);
+	num_modes += drm_add_edid_modes(connector, edid);
+
 	if (plat_data && plat_data->panel)
 		num_modes += drm_panel_get_modes(plat_data->panel);
 
@@ -1055,13 +1065,6 @@ static void analogix_dp_bridge_enable(struct drm_bridge *bridge)
 	if (dp->dpms_mode == DRM_MODE_DPMS_ON)
 		return;
 
-	if (dp->plat_data && dp->plat_data->panel) {
-		if (drm_panel_prepare(dp->plat_data->panel)) {
-			DRM_ERROR("failed to setup the panel\n");
-			return;
-		}
-	}
-
 	if (dp->plat_data && dp->plat_data->power_on)
 		dp->plat_data->power_on(dp->plat_data);
 
diff --git a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h
index 6960ab3..5348b1b 100644
--- a/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h
+++ b/drivers/gpu/drm/bridge/analogix/analogix_dp_core.h
@@ -20,6 +20,28 @@
 #define MAX_CR_LOOP 5
 #define MAX_EQ_LOOP 5
 
+/* I2C EDID Chip ID, Slave Address */
+#define I2C_EDID_DEVICE_ADDR			0x50
+#define I2C_E_EDID_DEVICE_ADDR			0x30
+
+#define EDID_BLOCK_LENGTH			0x80
+#define EDID_HEADER_PATTERN			0x00
+#define EDID_EXTENSION_FLAG			0x7e
+#define EDID_CHECKSUM				0x7f
+
+/* DP_MAX_LANE_COUNT */
+#define DPCD_ENHANCED_FRAME_CAP(x)		(((x) >> 7) & 0x1)
+#define DPCD_MAX_LANE_COUNT(x)			((x) & 0x1f)
+
+/* DP_LANE_COUNT_SET */
+#define DPCD_LANE_COUNT_SET(x)			((x) & 0x1f)
+
+/* DP_TRAINING_LANE0_SET */
+#define DPCD_PRE_EMPHASIS_SET(x)		(((x) & 0x3) << 3)
+#define DPCD_PRE_EMPHASIS_GET(x)		(((x) >> 3) & 0x3)
+#define DPCD_VOLTAGE_SWING_SET(x)		(((x) & 0x3) << 0)
+#define DPCD_VOLTAGE_SWING_GET(x)		(((x) >> 0) & 0x3)
+
 enum link_rate_type {
 	LINK_RATE_1_62GBPS = DP_LINK_BW_1_62,
 	LINK_RATE_2_70GBPS = DP_LINK_BW_2_7,
@@ -161,6 +183,7 @@ struct analogix_dp_device {
 	int			dpms_mode;
 	int			hpd_gpio;
 	bool                    need_force_hpd;
+	unsigned char           edid[EDID_BLOCK_LENGTH * 2];
 
 	struct analogix_dp_plat_data *plat_data;
 };
@@ -260,27 +283,4 @@ int analogix_dp_is_video_stream_on(struct analogix_dp_device *dp);
 void analogix_dp_config_video_slave_mode(struct analogix_dp_device *dp);
 void analogix_dp_enable_scrambling(struct analogix_dp_device *dp);
 void analogix_dp_disable_scrambling(struct analogix_dp_device *dp);
-
-/* I2C EDID Chip ID, Slave Address */
-#define I2C_EDID_DEVICE_ADDR			0x50
-#define I2C_E_EDID_DEVICE_ADDR			0x30
-
-#define EDID_BLOCK_LENGTH			0x80
-#define EDID_HEADER_PATTERN			0x00
-#define EDID_EXTENSION_FLAG			0x7e
-#define EDID_CHECKSUM				0x7f
-
-/* DP_MAX_LANE_COUNT */
-#define DPCD_ENHANCED_FRAME_CAP(x)		(((x) >> 7) & 0x1)
-#define DPCD_MAX_LANE_COUNT(x)			((x) & 0x1f)
-
-/* DP_LANE_COUNT_SET */
-#define DPCD_LANE_COUNT_SET(x)			((x) & 0x1f)
-
-/* DP_TRAINING_LANE0_SET */
-#define DPCD_PRE_EMPHASIS_SET(x)		(((x) & 0x3) << 3)
-#define DPCD_PRE_EMPHASIS_GET(x)		(((x) >> 3) & 0x3)
-#define DPCD_VOLTAGE_SWING_SET(x)		(((x) & 0x3) << 0)
-#define DPCD_VOLTAGE_SWING_GET(x)		(((x) >> 0) & 0x3)
-
 #endif /* _ANALOGIX_DP_CORE_H */
-- 
2.1.2





More information about the Linux-rockchip mailing list