[PATCH v5 1/4] ethernet: arc: Add support for Rockchip SoC layer device tree bindings

Beniamino Galvani b.galvani at gmail.com
Wed Sep 3 14:12:20 PDT 2014


On Wed, Sep 03, 2014 at 04:52:42PM +0000, Romain Perier wrote:
> This patch defines a platform glue layer for Rockchip SoCs which
> support arc-emac driver. It ensures that regulator for the rmii is on
> before trying to connect to the ethernet controller. It applies right
> speed and mode changes to the grf when ethernet settings change.

Hi Romain,

on a Radxa Rock when I try to remove the emac_rockchip module the
board locks up when calling clk_disable_unprepare(priv->refclk). The
tree is a net-next + your series, I don't know if I need some other
patches.

There is also the following build warning due to the emac dependency
on REGULATOR which in principle seems correct, but looking at other
drivers I wonder why they use the regulator APIs but don't have the
same dependency.

drivers/regulator/Kconfig:1:error: recursive dependency detected!
drivers/regulator/Kconfig:1:       symbol REGULATOR is selected by MDIO_SUN4I
drivers/net/phy/Kconfig:159:       symbol MDIO_SUN4I depends on PHYLIB
drivers/net/phy/Kconfig:5:         symbol PHYLIB is selected by ARC_EMAC_CORE
drivers/net/ethernet/arc/Kconfig:20:      symbol ARC_EMAC_CORE is selected by EMAC_ROCKCHIP
drivers/net/ethernet/arc/Kconfig:35:      symbol EMAC_ROCKCHIP depends on REGULATOR

Regards,
Beniamino



More information about the Linux-rockchip mailing list