[PATCH v13 4/5] ARM: dts: add main Thermal info to rk3288

[Dmitry Torokhov]

Hi Caesar,

On Thu, Oct 23, 2014 at 05:40:06PM +0800, Caesar Wang wrote:
> This patch is depend on rk3288-thermal.dtsi,or
> it will compile error.
> 
> If the temperature over a period of time High,over 120C
> the resulting TSHUT gave CRU module,let it reset
> the entire chip,or via GPIO give PMIC.
> 
> Signed-off-by: Caesar Wang <caesar.wang at rock-chips.com>
> ---
>  arch/arm/boot/dts/rk3288.dtsi | 21 +++++++++++++++++++++
>  1 file changed, 21 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/rk3288.dtsi b/arch/arm/boot/dts/rk3288.dtsi
> index cb18bb4..85fc17a 100644
> --- a/arch/arm/boot/dts/rk3288.dtsi
> +++ b/arch/arm/boot/dts/rk3288.dtsi
> @@ -15,6 +15,7 @@
>  #include <dt-bindings/interrupt-controller/arm-gic.h>
>  #include <dt-bindings/pinctrl/rockchip.h>
>  #include <dt-bindings/clock/rk3288-cru.h>
> +#include <dt-bindings/thermal/thermal.h>
>  #include "skeleton.dtsi"
>  
>  / {
> @@ -66,6 +67,7 @@
>  				 216000  900000
>  				 126000  900000
>  			>;
> +			#cooling-cells = <2>; /* min followed by max */
>  			clock-latency = <40000>;
>  			clocks = <&cru ARMCLK>;
>  		};
> @@ -346,6 +348,19 @@
>  		status = "disabled";
>  	};
>  
> +	tsadc: tsadc at ff280000 {
> +		compatible = "rockchip,rk3288-tsadc";
> +		reg = <0xff280000 0x100>;
> +		interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru SCLK_TSADC>, <&cru PCLK_TSADC>;
> +		clock-names = "tsadc", "apb_pclk";
> +		pinctrl-names = "default";
> +		pinctrl-0 = <&otp_out>;
> +		#thermal-sensor-cells = <1>;
> +		hw-shut-temp = <120000>;

I do not think this is a good value. You have (in the other DTS file)
passive trip point at 80 and critical (which should result in orderly
shutdown) at 125. But here you define hardware-controlled shutdown at
120C, which is backwards. You should have:

passive <= critical <= hardware

Thanks.

-- 
Dmitry